Siemens SC76M530GB Operating Instructions Manual

Also see for dishwasher: Instructions for use Operating instructions Operating instructions Operating instructions Operating instructions

en22– Some models:The plastic housing on the waterconnection contains an electric valve,the connecting cables are in the supplyhose. Do not cut through this hose,do not immerse the plastic housing inwater.DeliveryYour dishwasher has been checkedthoroughly in the factory to ensure that it isin working order. This may cause smallwater stains. These will disappear after thefirst wash cycle.Technical specificationsWeight:max. 27 kgVoltage:220–240 V, 50 Hz or 60 HzConnected load:1.9–2.3 kWFuse:10/16 AWater pressure:at least 0.05 MPa (0.5 bar), maximum1 MPa (10 bar). At a higher waterpressure: connect pressure-reducing valveahead.Inlet rate:minimum 10 litres/minuteWater temperature:cold water; hot water max. temperature60 °C.InstallationThe required installation dimensions canbe found in the installation instructions.Level the appliance. Ensure that theappliance is situated securely on the floor.– The appliance can easily be installed ina fitted kitchen between wooden andplastic walls. If the plug is not freelyaccessible, an allpole disconnectorwith a contact opening of at least 3 mmmust be fitted on the installation side tosatisfy the relevant safety instructions.Waste-water connection– The required work sequence can befound in the installation instructions. Ifrequired, fit a siphon with an drainageconnection.– Connect the waste-water hose to thedrainage connection of the siphon withthe enclosed parts.Ensure that the drainage hose is notkinked, crushed or twisted and thatthere is no cover plate in the drainageto prevent the waste water from flowingout!Fresh water connection– Connect the fresh-water connection tothe tap according to the installationinstructions with the enclosed parts.Ensure that the fresh-water connectionis not kinked, crushed or twisted.– When replacing the appliance, alwaysuse a new water supply hose.Water pressure:at least 0.05 MPa (0.5 bar), maximum1 MPa (10 bar). At a higher waterpressure: connect pressure-reducing valveahead.Inlet rate:minimum 10 litres/minuteWater temperature:cold water preferred; hot water max.temperature 60 °C.