Siemens SAT 12 Installation Instructions Manual

Fig. 38AA11830 - E0 - 10/10/2003 - UK - SNR 811830.0-001Fig. 2Fig. 1Fig. 4A BFig. 51. Product descriptionThis transponder is supplied either as an SAT 12 witha housing or an SMT 12 without the housing.2. Supply packageThe SAT 12 package contains the following :- One SAT 12 Housing (only SAT 12).- One SMT 12 transponder (board).- 8 terminating resistors (4.7 kOhm).- One set (4 off) of mounting studs (only SMT 12).- One SLT 12 language kit complete with :- Installation instructions.- One Wiring diagram.- One cable with socket connector for externaltamper contact (only SMT 12).3. Mounting instructionsThe SAT 12 and SMT 12 are designed for mountingin dry indoor rooms. They must not be exposed toeither dripping or splashing water. The SMT 12 isdesigned for installation either in an power supplyunit or a suitable flush-type box.3.1 Open housing (fig. 1)1 - Slacken the retaining screw Q.2 - Remove the cover W.3.2 Product overview (fig. 2)Housing (SAT 12 only) with the following:- Mounting holes W.- Holes or knockouts Q,E for cables.- Eye R for sealing.- Locking tab T to hold the circuit board.- SMT 12 circuit board Y.- Knockout U for the back tamper contact screw.3.2.1 SMT 12 circuit board (fig. 3)- Wire jumpers Q for programming glass breakalarm inputs.- Plug connector W for external tamper contact,connected in parallel to the tamper contact E.- Tamper contact of SAT 12 housing E.- Four inputs R.- Two «open collector» outputs T.- E-Bus connection Y.- Address key U.- LED I flash if the E-Bus communication is correct3.3 Fit SAT 12 housing (fig. 4)1 - If necessary, break out the knockouts forcables (A).2 - Insert cables.3 - Secure the base using 2 screws (B).3.4 Fit SMT 12 circuit board1 - Engage the mounting studs in the holes (fig. 5A).2 - Fit circuit board (fig. 5B).SAT 12/SMT 12Installation instructionssSLT 12 UK20 800 771.0-010QWUYTREWQQRTYUIWEB4+ B3E-BusEmplyB2 B1- NC NCO2 O1 Z4 Z3 Z2 Z11 2 3 4 5 6 7 8 9

/ 2

Related manuals for Siemens SAT 12