Siemens RUGGEDCOM WIN5158-V-GPS Installation Manual

Chapter 2Installing the Subscriber UnitRUGGEDCOM WIN5158-V-GPSInstallation Guide6 General ProcedureIMPORTANT!This product should be installed in a restricted access location where access can only be gained byauthorized personnel who have been informed of the restrictions and any precautions that must betaken. Access must only be possible through the use of a tool, lock and key, or other means of security,and controlled by the authority responsible for the location.IMPORTANT!Install equipment in accordance with the electrical code relevant to the country of installation, such as:• the National Electrical Code (NEC), ANSI/NFPA 70• the Canadian Electrical Code (CEC), Part 1, CSA C22.1• the National Electrical Safety Code IEEE C2 (when applicable)Unless marked or otherwise identified, the Standard for the Protection of Electronic Computer/DataProcessing Equipment, ANSI/NFPA 75, also applies.IMPORTANT!Outdoor exposed communication lines longer than 40 m (140 ft) must be considered as TNV-1 circuits.The installer must make sure the power supply and network ports are designed for full compliance withthe standards for TNV-1 telecommunication networks.CONTENTS• Section 2.1, “General Procedure”• Section 2.2, “Unpacking the Subscriber Unit”• Section 2.3, “Site Preparation and Precautions”• Section 2.4, “Mounting the Subscriber Unit”• Section 2.5, “Installing the Antennas”• Section 2.6, “Grounding the Subscriber Unit”• Section 2.7, “Connecting Power and Data”• Section 2.8, “Weatherproofing the Subscriber Unit”Section 2.1General ProcedureThe general procedure for installing the subscriber unit is as follows:1. Review the relevant certification information for any regulatory requirements. For more information, refer toSection 5.1, “Approvals”.2. Unpack and inspect the subscriber unit components. For more information, refer to Section 2.2, “Unpackingthe Subscriber Unit”.3. Mount the subscriber unit to a pole, wall or tower. For more information, refer to Section 2.4, “Mounting theSubscriber Unit”.4. Install and connect the antenna(s). For more information, refer to Section 2.5, “Installing the Antennas”.5. Make sure the subscriber unit is grounded. For more information, refer to Section 2.6, “Grounding theSubscriber Unit”.