Siemens INOX PRO SIMATIC IPC277D Service Manual

Also see for INOX PRO SIMATIC IPC277D: Operating manual Operating instructions Quick install guide

Contents

Replacing the seal of the compartment coverSIMATIC IPC277D 19" INOX PRO, SIMATIC IFP1900 INOX PRO8 Service Manual, 03/2015, A5E35751762-AA1. Remove the six screws of the terminal compartment cover.2. Remove the terminal compartment cover.CAUTIONDo not drop the terminal compartment coverDropping the terminal compartment cover may result in minor injuries or damages to thedevice.Prevent the terminal compartment cover from dropping, especially when it is mountedon a stand or support arm.3. Remove the seal of the terminal compartment cover.4. Insert the spare seal as shown in the figure.5. Check the seal for correct seat; make sure that the bore holes of the seal enclose thecollar of the press-fit components, see marked locations.6. Place the terminal compartment cover on the terminal compartment and reinsert the sixscrews.7. Tighten all six screws with a torque of 3.5 Nm.