AdministrationA31003-S2010-M100-10-7619, 27/08/20083-90 HiPath 2000/3000/5000 - OpenStage Family, Administration Manualadministration.fmDiagnostics3.16.3 QoS ReportsThe generation of QoS (Quality of Service) reports which are sent to a QCU server (see Sec-tion 3.3.8, “SNMP”) is configured here.Settings• Report mode: Sets the conditions for generating a QoS report.Value range:• "OFF": No reports are generated.• "EOS Threshold exceeded": Default value. A report is created if a) a telephone con-versation longer than the Minimum session length has just ended, and b) a thresholdvalue has been exceeded during the conversation.• "EOR Threshold exceeded": A report is created if a) the report interval has just passed,and b) a threshold value has been exceeded during the observation interval.• "EOS (End of Session)": A report is created if a telephone conversation longer thanthe Minimum session length has just ended.• "EOR (End of Report Interval)": A report is created if the report interval has justpassed.• Report interval (seconds): Time interval between the periodical observations.Default: 60.• Observation interval (seconds): During this time interval, the traffic is observed. Thefixed value is 10.• Minimum session length (100 millisecond units): When the Report mode is set to "EOSThreshold exceeded" or "EOS (End of Session)", a report can be created only if the dura-tion of the conversation exceeds this value.Default: 20.• Maximum jitter (milliseconds): When the jitter exceeds this value, a report is generated.Default: 20.• Average round trip delay (milliseconds): When the average round trip time exceeds thisvalue, a report is generated.Default: 100.Non-compressing codecs:The following threshold values apply to non-compressing codecs.> For details about the functionality, please refer to the release notes.
