A31003-K1160-S100-03-7620Service Manual 4-51InstallationInstalling a TFE - Entrance Telephone Interface4.12.2 Model S30817-Q936-C282 - BrazilInstallation ProceduresThis interface can be configured to work in Pager or Entrance Telephone mode.Pager ModeEntrance Telephone ModeStep Procedure1. Set jumper 1 (J1) to ON and jumper 2 (J2) to OFF (see “Entrance TelephoneInterface” on page 3-62).2. Configure the system for Entrance Telephone/Door Opener mode and specify theextensions for answering calls. Specify also at which extension the interface will beinstalled.3. Connect the interface to the Entrance Telephone extension by using contacts 1 and2 on the X2 connector.4. To activate Pager mode, lift the handset at one of the answering extensions and dialthe Entrance Telephone number. Once the appropriate number is dialed, the callingextension is connected to the Entrance Telephone, but without voice capability.5. For voice capability, dial “8”. The ambient sound will stop and you will be able toleave a message. The sound will be amplified in all speakers connected to theamplifier.6. To disable voice capability, dial “9“. If the sound is not disabled manually, it willtimeout automatically after 15 seconds. To enable the automatic timeout, set jumper3 (J3) to OFF.7. “Performing a Visual Inspection” on page 4-59.8. Configure the required data (see “Operation” on page 6-1).The length of the cables between the X2 connector and the PABX must not exceed32.8 feet (10 meters).Step Procedure1. Set jumper 1 (J1) to OFF (see “Entrance Telephone Interface” on page 3-62).
