Siemens EH6 MD2 Series Instruction Manual

Also see for EH6 MD2 Series: Instruction manual

14To access the basic settingsThe hob must be turned off.1. Turn on the hob with the main switch.2. Within the next 10 seconds, press the 0 symbol and hold for4 seconds.™‚ is displayed on the left of the screen and ‹ on the right.3. Press the 0 symbol several times until the indicator for thedesired function appears on the left of the screen.4. Then select the required setting using the programming zone.5. Press the 0 symbol again and hold for more than 4seconds.The settings will have been correctly saved.QuitTo leave the basic settings, turn off the hob at the main switch.Care and cleaningThe advice and warnings contained in this section aim to guideyou in cleaning and maintaining the hob, so that it is kept in thebest possible conditionHobCleaningClean the hob after each use. This prevents food remains lefton the surface from burning. Wait until the hob is cold enoughbefore attempting to clean it.Only use cleaning products specifically designed for glass-ceramic hobs. Follow the instructions provided on thepackaging.Do not use:■ Abrasive products■ heavy-duty cleaners, like oven sprays and stain removers■ Pads that may scratch■ High-pressure or steam cleanersGlass scraperRemove dried-on food remains using a glass scraper.1. Release the scraper safety catch2. Use the blade to clean the hob surfaceDo not attempt to clean the hob surface with the base of thescraper. This could result in scratching.ã=Risk of injury!!The blade is extremely sharp. Risk of cuts. Protect the bladewhen not in use. Replace the blade immediately when anyimperfections are found.Care of the applianceApply an additive to protect and preserve the hob. Follow theadvice and warnings provided with the product.™ˆ Power-Management function‹ = Deactivated.*‚ = 1,000 W. minimum power.‚ = 1,500 W.ƒ = 2,000 W.etc.Š or Š. = maximum power of the hob.™Š Hotplate time selection‹ Unlimited: the last hotplate programmed remains selected.*‚ Limited: The hotplate will only remain selected for 10 seconds.™‹ Return to basic settings‹ Personal settings.*‚ Return to factory settings.Indicator Function*Factory settings