en19Switching the dishwasher OFFSeveral minutes after the programme hasended:Open the door when the programmehas ended.Set main switch 1 to OFF.Turn the water tap off.(Does not apply when Aqua-Stop unithas been fitted)Remove dishes, etc. when they havecooled down.Interrupting the programmeOpen the door. Caution! There is a riskof water squirting out from inside theappliance. Do not open the door fullyuntil the spray arm has stoppedrotating.Set main switch 1 to OFF.Indicator lights extinguish. Theprogramme is retained in the dish-washer memory.If the hot water was switched ON or theappliance has already heated up andthen the appliance door opened, leavethe door ajar for several minutes andthen close.Otherwise, the appliance door may flyopen due to expansion.In order to continue with the storedprogramme, set the main switch to ONagain and close the door.Time delay ** on applicable modelsYou can delay the start of the programmein 1-hour steps up to 19 hours.Switch on the appliance.Press the timer programming button3 until the digital display 4 jumpsto .Keep pressing the timer programmingbutton until the required time isdisplayed.To delete the timer programming,keep pressing the button untilis displayed.You can change your programmeselection at any time until theprogramme starts.Remaining running time displayWhen the appliance has started, theexpected programme running time isdisplayed. The programmed running timeis affected by the water temperature, thenumber of dishes, as well as the degreeof soiling. If these conditions are changed,the running time (depending on theselected programme) can vary greatly.As the effect is not detected until aprogramme is running, the time maybe longer or shorter than expected.Intensive dryingIf the “Intensive drying” function isactivated, the temperature of the final rinseis increased in all programmes and youwill therefore receive an improved dryingresult. (Note the higher temperature maynot be suitable for fragile utensils.)Hold down the programme button Aand switch on the main switch.Release both buttons.The digital display 4 flashes (on)or (off).To change the setting, press theprogramme button A .Switch off the main switch 1 ;the setting is stored.