en27Fault findingResolving minor problemsyourselfExperience has shown that you canresolve most problems that arise duringnormal daily usage yourself, withouthaving to call out a service engineer. Notonly does this save costs, but it alsomeans that the appliance is available foruse again that much sooner. The followinglist of common occurrences and theirremedies should help you identify thecauses of most problems.Problems ...... when the appliance isswitched onIncorrect language set.Return to language selection1. Switch off the appliance.2. Switch on the appliance, holdingdown the main switch until thedisplay is lit.3. Select the language andacknowledge with “ok”.The appliance does not start.The mains fuse has tripped.The appliance plug has not beeninserted.The appliance door has not beenshut properly.The appliance door was closedwithout starting the programmefirst.Some time after the programmehas started, a continuous buzzeris emitted.The appliance is not being filled withwater. When the appliance door isopened, “Check water supply!” isindicated.Tap not turned on.Turn on the tap fully and pressthe “Continue” buttonon the appliance. Then close theappliance door to continue theprogramme.The filter on the water supply hoseis blocked.Switch off the appliance and pullout the mains plug. Turn off thetap. Then clean the filter which issituated at the connection of theAqua Stop or supply hose. Finally,restore the power, turn on the tap,switch on the appliance and closethe door to continue theprogramme.WarningRemember:The appliance may be repairedby a technician only. Improperrepairs may causeconsiderable damage and/orinjure the user.