Menu
Siemens DMS8000 MP4.81 Operation Manual
Also see for SPC4000: Installation & configuration manual
                                            |
2 Configuring intrusion control unitsConfiguring an SPC4000/SPC5000/SPC600018Building Technologies A6V10359489_a_enCPS Fire Safety 30.09.2016– In case of network link (see FigureSetting the network communicationoptions), set the IP address of the SI410 control unit and the TCP PortNumber used in the network communication.Setting the serial communication optionsSetting the network communication options2.2 Configuring an SPC4000/SPC5000/SPC6000The SPC4000, SPC5000 and SPC6000 are intrusion detection units belonging tothe SPC series. They can support both wired and wireless intrusion devices (truehybrid controller) and a LAN interface possibly integrated by additionalcommunications modules (PSTN/GSM/RF). Starting from SPC V3.1 all the SPCmodel types support Ethernet connection.Intrusion inputs can be operated in groups, organised inAreas andZones. Exactlimits depend on the SPC model.The SPC units can communicate to an external system over a network TCP/IPconnection. The MM8000/MK8000 systems can support the FlexC protocol(starting from SPC V3.6) and the EDP protocol (Europlex Datagram Protocol). Thetwo protocols are managed by 2 different drivers. The SPC panel can be linked to 1driver only, but you can create both drivers in the SPC project with a single license.The FlexC protocol is an encrypted protocol which provides more information andcommands than the EDP protocol, and offers a redundancy mechanism whichsupports up to 9 backup physical paths between the SPC panel and themanagement station. |
Related manuals for Siemens SPC4000
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved