Siemens D1085-A Additional Technical Manual

Contents

Additional Technical ManualA26361-D1085-Z180-2-7619 Page 1IntroductionThis technical manual applies for the mainboard D1085. This system board is available in differentconfiguration levels. Depending on the hardware configuration of your device, it may be that youcannot find several options in your version of the system board, even though they are described.Further information e. g. the complete Technical Manual for the D1085 and the Reference Manualfor the BIOS Setup are provided on the "Drivers & Utility" CD. For detailed information pleaselook at chapter 3.1 FeaturesFunction Version VersionD1085-A D1085-EProcessor Intel PentiumII,233 - 333 MHzIntel CeleronIntel PentiumII,233 - 333 MHzIntel CeleronChipset Intel 440LX Intel 440EXAGP connector X XWake on LAN (WOL) connector X -USB X XIrDA connector X -Chipcard reader X -Keyboard on X -BIOS Fax - -Quiet Boot X XDMI X XSystemmonitoring X -DIMM 3 2Memory ECC Support X -FAX On - -PCI Slots* 4 4ISA Slots* 3 3* = 1 PCI/ISA slot is shared2 Mechanics! Computer mainboards and components contain very delicate IC chips. To protectthem against damage caused from electric static, you have to follow someprecautions:• Unplug your computer when you work inside.• Hold components by the edge, don’t touch their leads.• Use a grounded wrist strap.Place the mainboard and the components on a grounded antistatic pad wheneveryou work outside the computer.Once you have installed the system board, you should remove the batteryprotection (i.e. the thin plastic plate between battery and contact spring).