Figure 2aFigure 2bFigure 2cA- Minimum 6” (152 mm)B- Minimum 6” (152 mm)C- Minimum 30” (762 mm)D- Minimum 2” (51 mm)F- Minimum 18” (458 mm)19 1/4 ”min. 6”min. 2 /16””Requirements for the cabinetADECBFFigure 1aAppliance installationIMPORTANT INFORMATIONFigure 1b1/ ”1 3/4 ”1 1/16 ”19 1/4 ”1/ ”1 ”Maximum depth of cabinets installed abovecooktop: 13" (330 mm.)E- Minimum 30” (762 mm)922 16min. 1022 16The seal ensures that the entire workseepage.If this item has not been fitted in the factory,remove the pan supports and the gas burnercovers and diffusers from your cooking hob,adhesiveappliancehob,Depending on the model, the clips and themay already be fitted; if this is the case, do notremove them under any circumstance.and turn it upside down.Now fit thesurfacewill be watertight, and prevents watersealsupplied with the onto the lower edgeof the cooking Fig. 2a,remove the clips fromthe attached accessories bag and screw theminto the lower points designed for this purpose,Fig. 2 b.3 -watertight seal (lower edge of the cooktop)Place the cooktop in the middle of theopening where it is to be inserted into the kitchenunit.Once the hob is fitted you should turn the clipand tighten the screw as shown in Fig. 2b. Fordisassembly, unscrew the clip and proceed in thereverse manner.If the oven is not installed under the cooktop,place a separator of non-flammable material toprevent access to the lower part of the cooktop.To install the cooktop over an oven, check thedimensions given in the installation manual.17