Siemens CP 1625 Operating Instructions Manual

Contents

Product overview2.4 Communications processor CP 1625DevCP 1625 / CP 1625DevOperating Instructions, 04/2018, A5E43075902-AA 17Interface/jumper X2000At interface X2000 you use the jumper to set whether the CP 1625Dev should be operated inan IPC or externally in Development mode.The interface is designated with the number ⑦ in the figure above.Figure 2-6 X2000Pin assignment DescriptionPins 1 and 2 Power supply via PCIe busPins 2 and 3 Power supply over X80 (with external use of the CP 1625Dev)NOTICEDamage to the IPC or the CP 1625DevDamage can occur if the jumper is inserted incorrectly on the X2000 interface and the IPCis then connected to a 24 V DC power supply.Set the position of the jumper on the X2000 interface according to the use of the CP 1625.Interface/jumper X2200At interface X2200 you use the jumper to set whether the SOC1 is to boot from NAND flash.The interface is designated with the number ⑤ in the figure above.Figure 2-7 X2200Pin assignment DescriptionPins 1 and 2 Boot from SPI flash (with use of the PCIe bus)Pins 2 and 3 Boot from NAND flash (with external use of the CP 1625Dev)Siemens Automation Parts