Siemens APOGEE USR5686 Installation Instructions Manual

Contents

product description

Installation InstructionsDocument No. 538-863October 10, 2011APOGEE ® Dial-Up ModemItem Number 538-863, Rev. GA Page 1 of 2Product DescriptionAccompanying U.S. Robotics Sportster 56K bpsmodem has been factory configured for use withAPOGEE Field Panel Dial-Up Application.APOGEE Auto-dial Application will reset Insight ®modem as needed.Contents of 538-859 CartonDescriptionQty.Sportster 56K Modem Model No. USR5686 1Power Adapter 120 Vac 1 17 foot Modular Phone Cord 1User Documentation Package 1Installation Instructions 11. For international installation, locally purchase U.S. RoboticsSportster 56K bps modem configured for the country whereused and program settings per this instruction.Prerequisites Analog telephone line connected through a NEC800.30 type telephone primary protector. UL497A telephone transient suppressorinstalled. For field panel a 538-600 telephonetransient suppressor is installed. Suppressorsold separately or included in modem kits, referto Installation Instruction 538-674. UL1449 listed power line protector. Not requiredif plugged into a field panel service box outlet oroutlet assembly.Expected Installation Time15 minutesWarning/Caution NotationsWARNING Personal injury/loss of lifemay occur if a procedure isnot performed as specified.CAUTION Equipment damage or lossof data may occur if theuser does not followprocedure as specified.WARNING:Connect modem to telephone line througha UL497A listed Telephone TransientSurge Suppressor and and NEC 800.30telephone primary protector.Required for modem installation in a fieldpanel used per Smoke Control Applicationand Engineering Manual (125-1806).WARNING:Connect modem to power through aUL1449 listed power protector or fieldpanel service box outlet.CAUTION:Modem must be connected to an analogtelephone line. Using a non-analog line(e.g., PBX, digital, multi-line) will damagemodem. A transient surge protector isrequired.CAUTION:This modem has been factory set toautomatically start in the dial-up mode.Refer to APOGEE Automation Start-UpProcedures Manual on InfoLink.External Switch SettingsDIP switches, located on the back of the modem,have been configured to start-up in the APOGEEDial-Up Application for field panels as shown in thefollowing illustration:Figure 1 Sportster Modem DIP Switches, Dial-UpAPOGEE Insight Auto-Dial Application will overrideDIP switch settings as needed.

/ 2

Related manuals for Siemens APOGEE USR5686