Siemens 6RA7086-6KS22 Operating Instructions Manual

Contents

Parameter list 05.0511-12 SIEMENS AG 6RX1700-0AD76SIMOREG DC Master Operating InstructionsPNU Description Value range[Unit]StepsNo. indicesFactorysettingTypeSeeChange(Access /Status)11.3 Access authorization levelsP051*Key parameters0 No access authorization6 Do not set (for use by DriveMonitor)7 Do not set (for use by DriveMonitor)9 Do not set (for use by DriveMonitor)21 Restore factory settingsAll parameters are reset to their defaults (factory settings).Parameter P051 is then automatically reset to factory setting"40".22 Execute internal offset compensation (see Section 7.4)25 Optimization run for precontrol and current controller (armatureand field) (see Section 7.5)26 Optimization run for speed controller (see Section 7.5)27 Optimization run for field weakening (see Section 7.5)28 Optimization run for compensation of friction and moment ofinertia (see Section 7.5)29 Optimization run for the speed controller with an oscillatingmechanical system (see Section 7.5)40 Access authorization to parameter values for authorized servicepersonnelsee column on left Ind: NoneFS=40Type: O2P052 = 3P051 ≥ 0OnlineP052*Selection of display parameters0 0 Display only parameters that are not set to original factorysettings1 Display only parameters for simple applications3 Display all parameters used0, 1, 3 Ind: NoneFS=3Type: O2P052 = 3P051 ≥ 0OnlineP053*Control word for the permanent memory [SW 1.7 and later]Disabling or enabling write accesses to the permanent memoryi001: Disabling or enabling write accesses to the parameter memory0 Only save parameter P053 in the permanent memory;parameter changes are active immediately but the changedvalues are only stored temporarily and are lost when theelectronics supply voltage is switched off1 Save all parameter values in the permanent memoryi002: Disabling or enabling write accesses to the memory of thenonvolatile process data0 Do not save nonvolatile process data in the permanentmemory1 Save all nonvolatile process data in the permanent memoryIf the nonvolatile process data are not stored (P053.002=0),data are lost when the electronics supply of the SIMOREG DCMaster is switched off, i.e. they have the value 0 after theelectronics supply is switched on again:K0240: Setpoint of the motor potentiometerK0309: Motor heatingK0310: Thyristor heatingK9195: Output of the 1st tracking/storage elementK9196: Output of the 2nd tracking/storage element0 to 11Ind: 2FS=1Type: O2P052 = 3P051 = 0on-lineP054 OP1S – Background lighting0 ON continuously1 ON when panel is in use0, 1 Ind: NoneFS=0Type: O2P052 = 3P051 ≥ 0Online