Menu
Sharp XG-C465X-L Setup Manual
Also see for Notevision XG-C435X-L: Operation manualSpecification sheetSpecifications
                                              |
-31Setting up the Projector Using RS-232C or TelnetSETUP MENU (Main Menu)[1]IP AddressIP address settings. (Page 34)[2]Subnet MaskSubnet mask settings. (Page 34)[3]Default GatewayDefault gateway settings. (Page 34)[4]User Name (Factory default setting : Not Re-quired)Setting of user name for security protection. (Page 34)[5]Password (Factory default setting : Not Required)Setting of password for security protection. (Page 35)[6]RS-232C Baud Rate (Factory default setting :9600 bps)Baud rate settings for the RS-232C terminals. (Page35)[7]Projector NameIt is possible to assign a projector name. (Page 35)[8]DHCP ClientDHCP Client settings. (Page 35)[A]Advanced SetupEnters ADVANCED SETUP MENU. (Page 36)[D]Disconnect AllDisconnect all connections. (Page 36)[V] View All SettingDisplays all setting values. (Page 32)Can also be used with ADVANCED SETUP MENU.[S] Save & QuitSave set values and quit menu. (Page 33)[Q]Quit UnchangedQuit menu without saving setting values. (Page 33)Note The factory default settings for the projector areas follows:DHCP Client : OffIP address : 192.168.150.2Subnet mask : 255.255.255.0Default gateway : 0.0.0.0ADVANCED SETUP MENU[1]Auto Logout Time (Factory default setting : 5 min-utes)Setting of time until automatic disconnection of net-work connection. (Page 36)[2]Data Port (Factory default setting : 10002)Setting the TCP port number used when exchang-ing data. (Page 36)[5]Network Ping TestIt is possible to confirm that a network connectionbetween the projector and a computer etc. is work-ing normally. (Page 37)[6]Accept IP Addr(1)[7]Accept IP Addr(2)[8]Accept IP Addr(3)[9]Accept All IP Addr (Factory default setting : Ac-cept All)For improved security, it is possible to set up to threeIP addresses allowing connection to the projector.Set IP addresses can be cancelled using [9] AcceptAll IP Addr. (Page 37)[0] Search Port (Factory default setting : 5006)Setting the port number used when searching forthe projector. (Page 38)[!] Restore Default SettingRestores all setting values that can be set using themenu to the default state. (Page 38)[Q]Return to Main MenuReturn to the main SETUP MENU. (Page 38)▼SETUP MENU ▼ADVANCED SETUP MENU---------------------------------SETUP MENU--------------------------------[1]IP Address [2]Subnet Mask [3]Default Gateway[4]User Name [5]Password[6]RS-232C Baud Rate [7]Projector Name [8]DHCP Client[A]Advanced Setup [D]Disconnect All[V]View All Setting [S]Save & Quit [Q]Quit Unchangedsetup>******************** ADVANCED SETUP MENU ***********************[1]Auto Logout Time [2]Data Port[5]Network Ping Test[6]Accept IP Addr(1) [7]Accept IP Addr(2) [8]Accept IP Addr(3)[9]Accept All IP Addr [0]Search Port[!]Restore Default Setting[Q]Return to Main Menuadvanced> |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved