Menu
Sharp SWD-77EH-BK Quick Start Manual
                 | |
NOTICE: When using a 5 gallon bottle, slide it into place as shown in illustration below.• If the probe tube A and B(see page 8) are not sealed, the pump will run a few minutes andthe night lights will flash. To correct, open the door, re-attach the probe, and close thedoor.• If the lights continue to flash, your bottle may be empty or there may be an issue with thewater tube lines. Call 0-800-1-225588 for assistance.3. Turn the switches at the back of the dispenser to ON.• The red switch controls the hot water. If you do not want hot water, leave this switchedOFF.• The blue switch controls the cold water. If you do not want cold water, leave this switchedOFF.Note:• For the unit to operate properly, the probe head must seal on the bottle and the door mustbe fully closed.• It will take up to 3 minutes for the reservoirs to fill with water. During this time, the pump willrun on and off. This is normal.• Each time you dispense water from the taps, the pump will turn on to refill the tanks. This isnormal.• Self Cleaning works every 4 hours for short time. Self Cleaning pump sound is normal.Dispensing Cold WaterNote: After setup, it will take up to 6 hours to get the water to its maximum cold temperature.During this time, the compressor may run continuously. Compressor works to build up icebank, this is normal.10 |
Related manuals for Sharp SWD-77EH-BK
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved