Sharp PZ-43HV2E Operation Manual

Also see for PZ-43HV2E: Parts list Service manual

Contents

This equipment complies with the requirements of Directives 89/336/EEC and 73/23/EEC as amended by 93/68/EEC.Dieses Gerät entspricht den Anforderungen der EG-Richtlinien 89/336/EWG und 73/23/EWG mit Änderung 93/68/EWG.Ce matériel répond aux exigences contenues dans les directives 89/336/CEE et 73/23/CEE modifiées par ladirective 93/68/CEE.Dit apparaat voldoet aan de eisen van de richtlijnen 89/336/EEG en 73/23/EEG, gewijzigd door 93/68/EEG.Dette udstyr overholder kravene i direktiv nr. 89/336/EEC og 73/23/EEC med tillæg nr. 93/68/EEC.Quest’ apparecchio è conforme ai requisiti delle direttive 89/336/EEC e 73/23/EEC, come emendata dalladirettiva 93/68/EEC.« Â„Í·Ù‹ÛÙ·ÛÁ ·ıÙfi ·ÌÙ·ÔÍÒflÌÂÙ·È ÛÙÈÚ ··ÈÙfiÛÂÈÚ Ù˘Ì Ô‰Á„È˛Ì ÙÁÚ EıÒ˘·˙ÍfiÚ EÌ˘ÛÁÚ 89/336/EOK Í·È73/23/EOK, ¸˘Ú ÔÈ Í·ÌÔÌÈÛÏÔfl ·ıÙÔfl ÛıÏÎÁÒ˛ËÁÍ·Ì ·¸ ÙÁÌ Ô‰Á„fl· 93/68/EOK.Este equipamento obedece às exigências das directivas 89/336/CEE e 73/23/CEE, na sua versão corrigida peladirectiva 93/68/CEE.Este aparato satisface las exigencias de las Directivas 89/336/CEE y 73/23/CEE, modificadas por medio de la93/68/CEE.Denna utrustning uppfyller kraven enligt riktlinjerna 89/336/EEC och 73/23/EEC så som kompletteras av 93/68/EEC.Dette produktet oppfyller betingelsene i direktivene 89/336/EEC og 73/23/EEC i endringen 93/68/EEC.Tämä laite täyttää direktiivien 89/336/EEC ja 73/23/EEC vaatimukset, joita on muutettu direktiivillä 93/68/EEC.SPECIAL NOTE FOR USERS IN THE U.K.The mains lead of this product is fitted with a non-rewireable (moulded) plug incorporating a 13A (AVCSystem)/13A (Plasma Display TV (Panel Unit)) fuse. Should the fuse need to be replaced, a BSI or ASTAapproved BS 1362 fuse marked or and of the same rating as above, which is also indicated on the pinface of the plug, must be used.Always refit the fuse cover after replacing the fuse. Never use the plug without the fuse cover fitted.In the unlikely event of the socket outlet in your home not being compatible with the plug supplied, cut off themains plug and fit an appropriate type.DANGER:The fuse from the cut-off plug should be removed and the cut-off plug destroyed immediately and disposed ofin a safe manner.Under no circumstances should the cut-off plug be inserted elsewhere into a 10A socket outlet, as a seriouselectric shock may occur.To fit an appropriate plug to the mains lead, follow the instructions below:IMPORTANT:The wires in the mains lead are coloured in accordance with the following code:Blue: NeutralBrown: LiveGreen & Yellow: EarthAs the colours of the wires in the mains lead of this product may not correspond with the coloured markingsidentifying the terminals in your plug, proceed as follows:• The wire which is coloured blue must be connected to the plug terminal which is marked N or coloured black.• The wire which is coloured brown must be connected to the plug terminal which is marked L or coloured red.Ensure that neither the brown nor the blue wire is connected to the earth terminal in your three-pin plug.Before replacing the plug cover make sure that:• If the new fitted plug contains a fuse, its value is the same as that removed from the cut-off plug.• The cord grip is clamped over the sheath of the mains lead, and not simply over the lead wires.IF YOU HAVE ANY DOUBT, CONSULT A QUALIFIED ELECTRICIAN.