Sharp PN-K322B Operation Manual

Also see for PN-K322B: Operation manual Operation manual Operation manual Operation manual Operation manual

24EnPbyPPbyP MODESets the display method.OFF .........Displays one screen.ON ...........Displays a main screen and a sub screen in a line.* When using PbyP mode, set HDMI DUAL to OFF and DisplayPort STREAM to SST (Single Stream).PbyP SOURCESelect the input signal of the sub-screen in PbyP mode.When the input mode is DisplayPort ....... HDMI1 or HDMI2When the input mode is HDMI1............... DisplayPort or HDMI2When the input mode is HDMI2............... DisplayPort or HDMI1nOTHERSSCREEN MOTIONPATTERNResidual images are reduced by moving the screen.OFF ................. SCREEN MOTION function is disabled.PATTERN1 ...... A black screen spreads from the bottom of the screen and thenshrinks to the bottom of the screen. If the monitor is installed in theportrait orientation, a black screen spreads from the left end of thescreen and then shrinks to the left end of the screen.PATTERN2 ...... A black bar moves from the left end to the right end of the screen.If the monitor is installed in the portrait orientation, a black barmoves from the top to the bottom of the screen.MOTION TIME 1Specify a time period (operating interval) until SCREEN MOTION starts.MOTION TIME 2Specify a time period during which SCREEN MOTION operates (time period during which the screen will move).POWER MANAGEMENTPOWER MANAGEMENT determines whether or not to switch modes from no signal to the input signal standby mode.SIZEChanges the screen size. (See page 17.)4096 DISPLAY POSITIONSets the position where the image is displayed (LEFT, CENTER,or RIGHT) when a signal with 4096 horizontal dots is input.When RIGHT or LEFT is set, a black band may appear in themiddle of the screen with some images.This setting is only valid when the input is HDMI and the screensize is Dot by Dot.MUTE AUDIOTemporarily mutes the sound. The sound is restored when OFF is selected.* If using the monitor buttons, hold both [MENU/ENTER] button and [VOL-/ ] button at the same time.INFORMATIONShows information about the monitor.When HDMI DUAL is set to ON, the signal information of each terminal appears in HDMI1and HDMI2 fields.When a button other than [VOL+/ ]/[VOL-/ ] button, brightness adjustment button ( / ) is pressed, or if no action istaken for 15 seconds, the display disappears.TIPS• When WHITE BALANCE is set to THRU, BLACK LEVEL, CONTRAST, TINT, COLORS, RGB INPUT RANGE, GAMMA,PRESET, USER and COPY TO USER cannot be set.• If COLOR MODE is set to sRGB, the following items cannot be set.WHITE BALANCE, PRESET, USER, COPY TO USER, and GAMMA• When the COLOR MODE is set to VIVID, GAMMA can not be adjusted.PATTERN2PATTERN1LEFT CENTER RIGHTMenu Items