Sharp PC-W100T Operation Manual

iNotice for Users in the USAFCC StatementWARNING - FCC Regulations state that any unauthorized changes or modificationsto this equipment not expressly approved by the manufacturer could void the user’sauthority to operate this equipment.Note: This equipment has been tested and found to comply with the limits for a ClassB digital device pursuant to Part 15 of the FCC Rules.These limits are designed to provide reasonable protection against harmfulinterference in a residential installation. This equipment generates, uses and canradiate radio frequency energy and, if not installed and used in accordance with theinstructions, may cause harmful interference to radio communications. However,there is no guarantee that interference will not occur in a particular installation. Ifthis equipment does cause harmful interference to radio or television reception,which can be determined by turning the equipment off and on, the user is encouragedto try to correct the interference by one or more of the following measures:• Reorient or relocate the receiving antenna.• Increase the distance between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that to which thereceiver is connected.• Consult the dealer or an experienced radio / TV technician for help.A shielded I/F cable is required to insure compliance with FCC regulation for ClassB computing equipment.* As an Energy Star Partner, SHARP has determined that this product meets theEnergy Star guidelines for energy efficiency.Declaration of ConformitySHARP PERSONAL COMPUTER, PC-W100 SeriesThis device complies with part 15 of the FCC rules. Operation is subject to the followingconditions:(1)this device may not cause harmful interference, and (2) this device mustaccept any interference recieved, including interference that may cause undesiredoperation.Responsible Party:SHARP ELECTRONICS CORPORATIONSharp Plaza, Mahwah, New Jersey 07430TEL: 1-800-BE-SHARP