Sharp MX-M202D Operation Manual

111ORIGINALSORIGINALS THAT CAN BE FAXEDOriginal sizes* Long originalsDepending on the resolution setting and the width of the original, there may not be sufficient space in memory tohold a long original. When a long original cannot be entirely scanned, select a lower resolution setting and/orshorten the original.Scanning area of originalWhen faxing an original, note that the edges of theoriginal cannot be scanned.Width of edges that cannot be scanned:5 mm from top and bottom edges, 6 mm (or less) from leftand right edgesAutomatic reduction of faxed documentIf the size (width) of the faxed document is greater than the receiving machine's paper size, the size will beautomatically reduced.You can turn off automatic reduction. In this case, the left and right edges will not be transmitted. (See "AUTOREDUCE TX" on page 105.)Minimum original size Maximum original sizeUsing the SPF/RSPF A5: 210 mm (width) x 148 mm (length)(8-1/2" (width) x 5-1/2" (length))A5R: 148 mm (width) x 210 mm (length)(5-1/2" (width) x 8-1/2" (length))297 mm (width) x 800 mm* (length)(11" (width) x 31-1/2"* (length))* Long documents can betransmittedUsing the document glass 297 mm (width) x 432 mm (length)(11" (width) x 17" (length))• Originals that are not a standard size (A5, A4, A4R, B4, A3, 8-1/2" x 11", 8-1/2" x 11"R (5-1/2" x 8-1/2", 5-1/2"x 8-1/2"R, 8-1/2" x 11", 8-1/2" x 11"R, 8-1/2" x 14", 11" x 17", A4, A4R if the machine uses inch-based papersizes)) can also be faxed.• There are restrictions on originals that can be scanned using the SPF/RSPF. For more information, see"NORMAL COPYING" in the Operation Guide for the machine.Faxed document width Receiving machine'spaper width Size after reduction RatioA3 (11" x 17") B4 (8-1/2" x 14") B4 (8-1/2" x 14") 1 : 0.78 (1 : 0.64)A3 (11" x 17") A4 (8-1/2" x 11") A4R (8-1/2" x 11"R) 1 : 0.5 (1 : 0.5)B4 (8-1/2" x 14") A4 (8-1/2" x 11") A4R (8-1/2" x 11"R) 1 : 0.64 (1 : 0.78)Note5 mm5 mmTotal of 6 mm orless