Menu
Sharp MAX-PRO 1182 Operator's Manual
                                                               |
MAX-PRO Operator Manual Original Printed in EnglishFAULT & ALERT MANAGEMENT4-3BAGGER/PRINTER WARNINGSFault Cause Possible Solution (S)Seal Bar not at Temperature -Bagger inhibited from cyclingSeal Bar is not at the required tem-perature for sealing.Bagger will not cycle until requiredtemperature has been reached.Low Pressure Air Timed Out Low Pressure Air Timed Out No intervention required by opera-tor.Recovery Mode Active Attempting to open the bag again. No action is required.Recovery Mode Feeding New Bag The bagger is feeding out a replace-ment bag. It could not open the orig-inal bag.No action is required.Bag Is Filled A bag has been filled and sealed inFiller Mode.No action is required.Bag Level Low Bag are getting low in box. Prepare to replace bags soon.Demo Mode Is Active Bagger's demo mode is active. Disable demo mode in Set-tings\Demo to turn off this warning.Factory Test Mode Is Active Bagger is running in Test Mode. Turn Factory Test OFF in FactorySetup\Factory Test.Machine Not Tested Bagger life cycle count is not over1,000 cycles .Bagger has to run continuously for1,000 cycles without a fault to clear.Printer Not Ready Waiting for printer to begin bagging. Load label into printer.Printer Ribbon Low Printer ribbon is nearly at minimumusage.Prepare to replace ribbon.Waiting For Printer Waiting for the printer to print beforefinishing the bagging cycle.Load label into printer.Printer Ribbon Ribbon not moving during print Verify ribbon is installed correctly. |
Related manuals for Sharp MAX-PRO 1182
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved