Menu
Sharp JH-3500U Installation & Operator's Manual
                                 | |
Contents
|
6Installation InstructionsBefore InstallationREAD ALL THE INSTRUCTIONS AND CAUTIONS MARKED ON THIS MANUAL, THE SOLAR POWER CONDITIONER, ANDTHE PV ARRAY BEFORE INSTALLATION.WARNING• All electrical work should be done in accordance with local and national electrical codes ANSI/NFPA70.• Connecting the solar power conditioner to the grid should only be done after receiving prior approval from the powercompany and performed only by a Sharp certified installer.CAUTION• The solar power conditioner is approximately 57 lbs. in weight. To avoid the damage of the solar power conditioner or theinstaller, do not drop the solar power conditioner.• To avoid the risk of fire and the malfunction of the solar power conditioner, the open circuit voltage of each string shouldbe lower than 350V and the short circuit current of each string should be lower than 10A.NOTE• The National Electrical Code (NEC) requires that the solar power conditioner be connected to a dedicated circuit, and noother outlets or device may be connected to this circuit. (See NEC section 690-64(b)(1)). The NEC also imposeslimitations on the size of the inverter and the manner in with it is connected to the grid. See NEC Section 690-64(b)(2).• When the PV array is exposed to light, it supplies a DC voltage to this equipment.LocationThe solar power conditioner should be installed outdoors and the solar power conditioner display indoors. Installation of thesedevices in an improper location may cause smoke or fire danger. Also refer to the IMPORTANT SAFETY INSTRUCTIONS sectionon page ii.Do not install the solar power conditioner in a location:• Higher than the altitude of about 3,000 feet above sea level• Prone to damage by sea water• Close to volatile corrosive gas or liquid (for example, locations where chemicals are processed, feedlots or poultry)• Exposed to direct sunlight• Prone to flooding or high levels of snow pack• Minimal or no air flow and high humidity• Condensation• Exposure to steam, vapor, or water• Exposure to direct cool air• Near television antenna or antenna cableUnpacking Carton BoxBefore installation, make sure all the items listed below are included within the carton box. If any of these items is missing ordamaged, notify your dealer immediately.• Solar power conditioner 1 unit• Bracket 1 piece• Screws (for the bracket) 10 pieces• Flat washer (for the bracket) 10 pieces• Screws (for the hanging the bracket) 1 piece• Solar power conditioner display 1 unit• Wiring cable for the solar power conditioner display 1 piece• Screws (for the display) 2 pieces• Operation manual 1 piece• Installation & Operator’s manual 1 piece |
Related manuals for Sharp JH-3500U
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved