2-3Setting the Operating and System Conditions2[1] Monitor outputWhen two cameras have been connected to IV-S30, you can switch back and forth between the imagefrom the cameras on one monitor. Also, the monitor screen can be divided into two parts to display thetwo images simultaneously.- Purpose of the settingTo set the conditions in which an image captured during measurement will be displayed on the runmenu.- Output monitor switchingThe monitor can be switched by two methods, i.e. key pressing or parallel input.(1) Monitor output switching by key pressesTo specify a monitor, select the "1MONITOR OUTPUT" option on the [TYPE RUN COND] menu.Before making this setting, select the cameras whose images will be shown (Camera 1 & 2, Camera1 & NG image). - See page 3-3.DescriptionMONITOR OUTPUTOn the MAIN OPS menu screen, move the cursor to [TYPE RUN COND], and press the SET key.F.IMG C1 L1MONITOR OUTPUT CAM1 CAM2 CAM1&2(HORIZ VERT)2CAPTURE IMG PARTIAL-IMG WHOLE-IMG NO[TYPE RUN COND]When CAM1&2 is selected for use.When CAM1&NG-IMG is selected for use1 2F.IMG NG L1MONITOR OUTPUT CAM1 NG-IMG CAM1&NG-IMG(HORIZ VERT)2CAPTURE IMG PARTIAL-IMG WHOLE-IMG NO[TYPE RUN COND]12CAM1CAM2CAM1&2* 1CAM1&2(HORIZ VERT)* 2CAM1&2(HORIZ VERT)* 2MONITOR OUTPUTCAM1NG-IMSCAM1&NG-IMG* 1CAM1&NG-IMG* 2(HORIZ VERT)CAM1&NG-IMG* 2(HORIZ VERT)Operating procedure1. Move the cursor to "1MONITOR OUTPUT" using the up and down keys and press the SET key.2. When "CAM1&2" is selected for use, move the cursor to "CAM1," "CAM2" or "CAM1&2(HORIZVERT )" using the left and right keys and press the SET key. When "CAM1&NG-IMG" is selectedfor use, move the cursor to "CAM1," "NG-IMG" or "CAM1&NG-IMG(HORIZ VERT)" using the leftand right keys and press the SET key.DescriptionDisplay the camera 1 image on the whole screen.Display the camera 2 image on the whole screen.Display the camera 1 image on upper half, and the camera 2 imageon lower half.Display the camera 1 image on left half, and the camera 2 image onright half.Indicat camera 1 is selected.When CAM2 is selected on1MONITOR OUTPUT, "C2" isdisplayed. When CAM1&2 isselected "C1/C2" will be displayed.Indicates NG image isselected.When CAM1 is selected on1MONITOR OUTPUT,"C1" is displayed. WhenCAM1&NG-IMG is selected,"C1/NG" will be displayed.Display the camera 1 image on the whole screen.Display the image on the whole screen.Display the camera 1 image on upper half, and the NG image onlower half.Display the camera 1 image on left halt, and the NG image onright half.*1 : When IV-S31M/S32M is used * 2 : When IV-S33M is usedWhen IV-S33M isselected, this willbe displayed.
