Sharp FO-1470 Operation Manual

Also see for FO-1470: Operation manual Service manual Service manual User manual

Loading the Imaging Film171. Installation6 Pull the empty spool toward the backof the compartment, unwinding thefilm as you pull.5 Cut the band which holds the spoolstogether with scissors, and remove it.Insert the remaining gear into theright end of the empty spool and theflange into the left end of the emptyspool. Make sure the tabs on the gearand the flange fit into the slots in theends of the spool (the gear has twotabs and the flange has one tab).7 Insert the empty spool into the backof the compartment so that the gearand the flange fit into the slots on thesides of the compartment.• Make sure that the gear engageswith the gear below it.1 tab2 tabsFlangeGear8 Wind the film slightly (rotate the gearon the right side of the empty spool)so that there is no slack in the film.Make sure that both edges of the filmwind onto the spool evenly.all-ux510A.book Page 17 Thursday, September 14, 2000 9:05 AM

/ 20

Related manuals for Sharp FO-1470