Sharp ER-A770 Installation Manual

Also see for ER-A770: Instruction manual Instruction manual Instruction manual Dealer knowledge book Manual

10) Fastening onthe table:Secure the Base cabinet using the screw.No. NAME USE Q’tyScrew (M4 × 16) Securing the UP-P16DP to thewooden table 4Screw (M4 × 20) Securing the UP-P16DP to themetal table 4Nut Securing the UP-P16DP to themetal table 4Lowering the height of the UP-P16DPRemove the standard Pole and attach the Base cabinet to theRatch .16. SRN I/F: Standard1) Connect to the SRN cable to the SRN connector .2) Install the Ferrite core to the SRN cable .3) Install the Nylon band to the SRN cable .Using the terminal resistor (50 ohm: QCNCM7145RCZZ).Insure that the system is terminated at each.17. RS232 I/F: Standard1) Connect the RS232 cable to the connector.2) Install the ferrite Core to RS232 cable.3) Install the ferrite core to the cables.13 1314 1415 15Fig. 19Fig. 20Fig. 21*Master Satellite SatelliteTerminator50ΩRTrunk cablesBranchcables(5m x 2)16.4ft.x 2Satellite SatelliteTerminator 50ΩRJJ conectorCable conectorFig. 22

/ 10

Related manuals for Sharp ER-A770