Sharp EM-F2056 Operation Manual

E-10GRIND1 Lay the appliance on the flat horizontal surface and make sure it is unplugged.2 Prepare 200 g roasted coffee beans, and then remove the Measuring Cup and Jug Lidand put the roasted coffee beans into the Jug, after it, close the Jug Lid and Measuringcup well in position.Note: The maximum capacity of food to be grinded must not exceed 200 g.3 Connect the appliance with power source, and then push the Power switch to “ON”position.4 Push the function switch to “Pulse” setting and the appliance starts to grind coffeebeans.5 After grinding for about 30 seconds, turn the Speed Switch to “OFF” position, and theappliance stops working.Note:• During operation, if the coffee powder is too thick to be grinded, operate by referring to thedescription of “Tamper” mentioned above.• Do not remove the Jug from the Motor Unit during working process. If it is necessary toremove the Jug, please firstly turn off the appliance to make it stop working and thenremove it.• The advisable operation time per time is 3 minutes and minimum 1 minute rest time mustbe maintained between two consecutive cycles. Allow the appliance to rest for at least 30minutes every 10 cycles.6 After finish working, move the Jug out of the Jug Support Pad, and then carefully takedown the Measuring Cup and Jug Lid, then pour and serve.CAUTION: The Speed Switch and Power Switch must be at “OFF” positions and the poweroutlet must be unplugged before removing the Jug.MAKE HOT SOUP1 Lay the appliance on the flat horizontal surface and make sure it is unplugged.2 Remove the Measuring Cup and Jug Lid, and then put the required ingredients intothe Jug and fill the Jug with appropriate amount of room-temperature purified water.The amount of mixture should not exceed 1000 ml. And then close the Jug Lid andMeasuring Cup well in position.3 Connect the appliance with power source, and then push the Power switch to “ON”position.4 Push the function switch to “Soup” setting and the appliance starts to make soup.NOTE: The machine runs slowly at the first 15 seconds and will accelerate when detecting food.5 After cooking for about 6 minutes, the Switch will turned off automatically.High speed blender_EMF2056.indb 10High speed blender_EMF2056.indb 10 10/5/2016 10:29:28 AM10/5/2016 10:29:28 AM