Sharp DV-L80 Operation Manual

SPECIAL NOTE FOR USERS IN THE U.K.The mains lead of this product is fitted with a non-rewireable (moulded) plugincorporating a 3A fuse.Should the fuse need to be replaced, a BSI or ASTA approved BS 1362 fusemarked or and of the same rating as above, which is also indicated on thepin face of the plug, must be used.Always refit the fuse cover after replacing the fuse. Never use the plug withoutthe fuse cover fitted.In the unlikely event of the socket outlet in your home not being compatible withthe plug supplied, cut-off the mains plug and fit an appropriate type.DANGER: The fuse from the cut-off plug should be removed and the cut-offplug destroyed immediately and disposed of in a safe manner.Under no circumstances should the cut-off plug be insertedelsewhere into a 13A socket outlet, as a serious electric shock mayoccur.To fit an appropriate plug to the mains lead, follow the instructions below:IMPORTANT: The wires in the mains lead are coloured in accordance with thefollowing code:Blue: NeutralBrown: LiveAs the colours of the wires in the mains lead of this product may not correspondwith the coloured markings identifying the terminals in your plug, proceed asfollows:—The wire which is coloured blue must be connected to the plug terminal whichis marked N or coloured black.—The wire which is coloured brown must be connected to the plug terminalwhich is marked L or coloured red.Ensure that neither the brown nor the blue wire is connected to the earthterminal in your three-pin plug.Before replacing the plug cover make sure that:—If the new fitted plug contains a fuse, its value is the same as that removedfrom the cut-off plug.—The cord grip is clamped over the sheath of the mains lead and not simplyover the lead wires.IF YOU HAVE ANY DOUBT, CONSULT A QUALIFIED ELECTRICIAN.