Menu
Sharp DL-HB9JP8 Installation Instructions Manual
  |
1Intended UseThe Sharp recessed High-Bay LED Lightis intended for retail, warehouse and otherindoor commercial applications.HIgH-Bay Led LIgHtInstaLLatIon InstrUctIonsModels: dL-HB9JP8dL-HB9JP4Caution – Safety StatementSWarning - Do not handle energized luminaires. Always turn off power beforeinstalling, removing, or inspecting.Qualified licensed professionals should perform all installation work.Installation must be completed in strict conformance with local building andelectrical codes.Do not dis-assemble the luminaire.Do not remove or attempt to operate without lens cover over LED.Warning – Do not expose wiring to edges of metal to prevent damage.Warning – For removal of luminaire, turn off power. Allow luminaire to coolbefore handling. Reverse process of installation for removal.Use and careIt is recommended to inspect and clean the fixture by a qualified licensedprofessional every three years.Do not wipe the luminaire with alkaline cleaning substance, gasoline, thinner,benzin, heating oil, alcohol, or polishing powder. Do not apply insect killer (itmay damage).Do not polish the metallic parts with cleanser or scrub brush (it may damage).sHarP eLectronIcs corPoratIonLed LUMInaIre 1-year LIMIted WarrantySharp Electronics Corporation warrants to the first consumer purchaser (the “Purchaser”) that this Sharp brand LED Luminaire (the “Product”), when shipped in its original container, will befree from defects in materials and workmanship, and agrees that it will, at its option, either repair or provide the Purchaser a replacement of the defective product or part thereof that is a newor remanufactured equivalent at no charge to the Purchaser for parts or repair labor for the period set forth below.Warranty Period for this Product:The warranty period for material defects and workmanship is 1 year from date of original purchase from Sharp or its authorized reseller.terms and conditions:The warranty will apply only when the Product is used with products or lighting systems which are installed, operated, or maintained in accordance with each of the following:• The National Electric Code (NEC)• The Standards for Safety of the Underwriters Laboratories, Inc. (ETL Listed)• The Standards of the American National Standards Institute (ANSI), and• The specifications supplied by Sharp for the Installation, operation and maintenance of the Product.This warranty will be void in the event the Product is (i) improperly installed, (ii) damaged, (iii) defaced, or (iv) subjected to neglect, accidental breakage or misuse, including but not limited to,failing to operate Product in accordance with Sharp specifications. Sharp shall not be responsible for any failure of the Product which is a result of external causes; natural catastrophe; powersurges or failure; improper power supply; fault or negligence of the Purchaser or user; improper or unauthorized alteration, use, handling, or storage; operating product in ambient temperaturethat exceeds ambient listing; or any cause other than a defect in the material or workmanship of the Product. Sharp reserves the right to examine all failed Products and in its sole discretion todetermine whether any Products are covered under the terms of this Limited Warranty.This Limited Warranty does not include any Purchaser’s material and labor costs required to remove, replace or ship the Product.Limitation of Liability:The warranties described herein shall be the sole and exclusive warranties granted by Sharp and shall be the sole and exclusive remedy available to the Purchaser. Correction of defects, in themanner and for the period of time described herein, shall constitute complete fulfillment of all liabilities and responsibilities of Sharp to the Purchaser with respect to the Product and shallconstitute full satisfaction of all claims, whether based on contract, negligence, strict liability or otherwise. In no event shall Sharp be liable, or in any way responsible, for any damages or defectsin the Product which were caused by repairs or attempted repairs performed by anyone other than an authorized servicer. Nor shall Sharp be liable or in any way responsible for any incidentalor consequential economic, property or special damage. Some states do not allow the exclusion of incidental or consequential damages, so the above exclusion may not apply to you.If any provision of this Limited Warranty, or part thereof, is held or deemed to be invalid, void or unenforceable, such holding shall not affect the validity and enforceability of the remainderof the Limited Warranty, and such other parts, provisions or clauses of the Limited Warranty shall be deemed to be severable.This device complies with Part 15 of the FCC rules. Operation issubject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may causeundesired operation.THIS LIMITED WARRANTY IS VALID ONLY IN THE FIFTY (50) UNITED STATES, THE DISTRICT OF COLUMBIA AND PUERTO RICO.disputes: Any claim or dispute regarding these warranties shall be governed by and construed in accordance with the laws of the State of New Jersey (US).Questions: Please contact your local Sharp representative or Sharp Customer Service at 1-877-312-LED1 (1-877-312-5331).Where to obtain service: Warranty service is available at a Sharp Authorized Service Center in the United States. To find the location of the nearest Sharp Authorized Service Center, callSharp toll free at 1-877-312-5331, e-mail Sharp at LEDsupport@sharpusa.com or visit online at www.sharpledlighting.comHow to obtain service: Call Sharp toll free at 1-877-312-5331 to obtain a Return Authorization Number and shipping instructions. After obtaining a Return Authorization Number, ship yourProduct prepaid to a Sharp Authorized Service Center. Be sure it is insured and packaged securely.Proof of Purchase will be required. |
Related manuals for Sharp DL-HB9JP4
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved