Sharp DK-UH2 Quick Start Manual

Also see for DK-UH2: Operation manual Quick start guide

Contents

power source

Locking tabBack of remote controlUSB STEREO SPEAKERAccessoriesRemote control x 1 AC/DC adaptor x 1RADPAA039AWZZ (DK-UH2)RADPAA036AWZZ (DK-UH2(BK))AC power lead x 1 USB cable x 1Before using remote controlBefore using remote control, please remove plastic shieldat battery holder.Remote control battery installation1 Whilst pushing the locking tab towards the centre ofthe remote control, slide out the battery holder.2 Remove the old battery from the battery holder, insertthe new battery and then slide the battery holder backinto the remote control.Use the “CR 2025”, coin lithium battery.Power sourceHHHHH Using with the AC/DC adaptor1 Plug the AC power lead into the AC/DC adaptor.2 Plug the AC/DC adaptor cable into the DC Input socketon the unit.3 Plug the AC power lead and switch on the powersupply. The display indicator lights up when the ACpower is applied. The POWER indicator will turn BLUEwhen the system is “ON”.Battery holderLocking tabPositive (+)side upPolarity (+)symbolBattery typeDC IN 6VAUX INDC IN 6VAUX IN213AC/DC adaptor cableDC INPUT socket(DC 6V)AC power leadAC/DC adaptorWall socket(AC 100 - 240 V ~ 50/60 Hz)Battery holderPlastic shieldRemote controlTINSEA209 AWZZ07H R KI 1DK-UH2This quick Start Guide will help you to correctly install and operate your system.Illustrations printed in this quick guide are for the model DK-UH2.MODEL

/ 2

Related manuals for Sharp DK-UH2