Menu
Sharp BP-FN11 Quick Start Manual
   |
Page 1Service Success Center: https://service.sharpamericas.com/Sharp Academy: https://satech.sharpamericas.com/Sharp-AcademyQuestions? Contact us at success@sharpsec.comProcedure 1: Testing components and sensors on the FinisherOBJECTIVESAt the completion of this exercise, you will be able to remove the Finisher and Punch Units,perform a Component ID, and review the necessary adjustments to ensure each unit’soptimal performance.Note: Each procedure starts on a new page. Continue until all procedures have beencompleted.RESOURCES• BP-FN11/12 Service Manual• BP-50/70 Service Manual, Chapter 6• BP-50/70 Installation Manual, Chapter 7 and 8Reference Guides:• In the BP-FN11/12 Service manual, find the “Exteriors” diagrams and “Internalmechanism” diagrams.• In the BP70C45 Service Manual, go to the “Details of Simulations” section.Perform the following:1. Remove the front cover of the Finisher and, by cheating the door switch, watch theoperation of the unit running in Non-Staple, Staple, and Pamphlet Mode.2. Perform Simulations 3-2 and 3-3 to check Sensors and Components.BP-FN11/12 & MX-PN14BFinisher Lab |
Related manuals for Sharp BP-FN11
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved