Sharp Aquos UQ17U Operation Manual

Also see for AQUOS LC-60LE650U: Setup guide Operation manual Setup guide Operation manual Operation manual

i_=__ i]%ii i{J!i¢ ii+i_++ii ¢i +===_iii _I;_+_/i i ;;;+iiiiiii,_[?+__++__+=1]+_i+ iiii)i%=_]+ ii+ iiiiiiiiiiiiiiiiiiiiiiiiiiiiiiiii)_[_I +1iilI+_!!iiiiii==iiiiiii_+_@_i 1ii_,,+i' !iiii_;, i_=_=_=_=_ iii_You can adjust the 3D image to the desired image qualityand make various settings for 3D image viewing.• Set AV MODE and "3D Brightness Boost" with "PictureSettings".• Set the 3D viewing settings with "Setup" > "3D Setup".• Which items can be selected/adjusted differs dependingon whether the TV is in 2D mode or in 3D mode.The audio and video settings can be changed to suit theprogram or input content being watched.3D: For a highly defined image in a normal lighting.GAME (3D}: Lowers image brightness for easier viewing.For the LE657U modelSTANDARD (3D): For a highly defined image in a normallighting.MOVIE (3D): For a movie.GAME (3D): Lowers image brightness for easier viewing.• You can select AV MODE by pressing AV MODE on theremote control unit.You can adjust the backlight of the TV for 3D image viewing.High/Middle/Low: Select a desired level of 3D BrightnessBoost.• When "High" or "Low" is selected, "Automatic LightSensor", "Backlight" and "Light Sensor Adjustment" arenot available.You can make various settings to enhance 3D imageviewing.This setting can be used to switch to 3D mode automaticallywhen a 3D identification signal is detected.Set the desired mode according to the type of media youare viewing, such as video from a connected device or videofrom an internet application.Mode 1: 3D mode is selected automatically when a 3Dsignal is detected while viewing video from a VODservice or HDMI-connected equipment.Mode 2: 3D mode is selected automatically when, inaddition to detecting a 3D signal while viewing videofrom a VOD service or HDMI-connected equipment, avideo pattern with "Side by Side" or "Top and Bottom"format is also detected.Off: Auto change is not performed.• This function does not work when the input source isComposite, Component, RGB or Analog/Digital tuner.Select the method for adjusting the 3D depth.Auto: The depth is adjusted automatically.Manual: You can manually adjust the depth using thefunction "Depth Change".• This function is only available when the input signal is3D.• This function may not be displayed depending on the typeof 3D signal.ENG 5-11