Menu
Sharp AY-ZP25TR Installation Manual
    |
PIPINGMax.pipinglength:AMax.heightdifference:BMin.pipinglengthAdditionalrefrigerant(piping lengthexceeds 10m)Chargelessmaxpipelength15m 10m 3m 20g/m 10m• Standard piping length is 5m.• When the outdoor unit is placed at a higher level than theindoor unit, provide a trap near the hose’s lead-in port.Use the refrigerant pipes shown in the table below.Pipe size Pipe thickness Thermal insulationLiquid side 1/4"(ø 6.35 mm) 0.8 mmThickness: 6 mm orthickerMaterial: Polyethyl-ene foamGas side• The thermal insulation should cover both the gas and liquidpipes.INSTALLATION DIAGRAMNOTES ON LOCATIONS• Installation must be made in accordance with the installation manual by.• After installation has complete, check that there is no leakage of refriger-ant gas.• Ventilate the room if refrigerant gas leaks during installation.Make in place and that the terminals are free of any excessforce from the• Form the cable so that the control box cover, the cord holder and cableholder are not loose.Indoor unitin the entire room.2.3. both sides and above the unit.5. unit and theremote control.6. Keep the air inlet clear of obstacles that could block incoming air.7. lighting.8. and extreme vi-brations.Outdoor unit1. Place the outdoor unit on a stable base.2.3. water.4. Water drain from the unit should be let out without problem.advisable as freezing could result.5. .6. Avoid locations exposed to machine oil vapor, salty air (facing the seashore,breakdown.7. where the unit can betampered with.8.9. Keep the air outlet opening free of any obstacle. This could affect the performance of the unitand create loud noises.TrapIndoorUnitOutdoorunitSPLIT AIR / AIR HEAT PUMPINSTALLATION MANUAL B617INDOOR UNIT OUTDOOR UNITAY-ZP25TR AE-Z25TRAY-ZP35TR AE-Z35TRcause refrigerant gas leakage.• When installing the unit, take care not to enter air substance other than theOtherwise, it will cause burst and injury as a result of abnormal high pressure in the refrig-erant cycle.• Be sure to connect the refrigerant pipe before running the compressor.Otherwise, it will cause burst and injury as a result of abnormal high pressure in the refrig-erant cycle.• Earth the unit.Incomplete earth may cause electrical shock.• If national legislations or type of installation requires earth leakage breaker,the legislation must be followed.• Arrange the drain hose to ensure smooth drainage.• Use the .1 MOUNTING PLATE1To mount the indoor unit onthe wall.5 DRY BATTERY2For the remote control.AAA batteries.91To secure the electricalcable.2 WALL PLUG9 the long screws(7).the special screw(2).6 SPECIAL SCREW(Black) 2• To mount the remote con-trol on the wall.• To mount the remote con-trol holder on the wall.10 MANUALS 1 Installation manual1 Operation manual3 LONG SCREW(M4.5x30) 77 Remote controlholder 1To mount the remote controlon the wall.11 SHEET(adhesive type) 1-cal cable.4 REMOTE CONTROL1To control remotely. 8 SHORT SCREW(M4x20) 112 DROPPER1To check the drain hose.ITEMS Q’ty APPLICATION ITEMS Q’ty APPLICATION ITEMS Q’ty APPLICATIONProvide as much installationair-conditioning.MIN.70MIN.50Length unit: mmMIN.100MIN.200MIN.200MIN.50MIN.50MIN.60(Recommended more than 100mm) |
Related manuals for Sharp AE-Z25TR
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved