1PART NAMEEXHAUST DUCT BACKPDVC-B107WRWZEXHAUST DUCT UPPERPDVC-B105WRWZDIVIDE PLATE LPSKR-A486WRWZDIVIDE PLATE RPSKR-A487WRWZRECTIFIER PLATE LPSKR-A484WRWZEXHAUST DUCT LEFTPDVC-B108WRWZEXHAUST DUCT RIGHTPDUC-B117WRWZEXHAUST DUCT BOTTOMPDVC-B106WRWZFRAME ASSEMBLYFDEC-A004WRKZSCREW(A)XHTS740P08000SCREW(B)XMMS841P13000SCREW(C)XMSS827P25000REAR SPACERPSPAFA003WRWZCUSHION 1 5/ 8 " x 16",15 mm x 405 mmPCUS-A245WRPZCUSHION 2 1/ 4 " x 24 3 / 8",5 mm x 618 mmPCUS-A247WRPZCUSHION 3 1 1/ 8" x 27 1/ 8",30 mm x 689 mmPCUS-A249WRPZCUSHION 4 1/ 4 " x 12",5 mm x 305 mmPCUS-A251WRPZCUSHION 5 1/ 4 " x 15",5 mm x 382 mmPCUS-A253WRPZINSTALLATION INSTRUCTIONSBUILT-IN KIT MODELIMPORTANT: This Built-In Kit is designed for use with Sharp SuperSteam Ovens specifying a RK-12S30Built-In Kit on the rating label on the front of the oven.The cabinet or wall opening must be within the following dimensions:HEIGHT 19" to 19 1 /8 " (482 mm - 486 mm)WIDTH 28" to 28 1 /4 " (710 mm - 719 mm)DEPTH 23 1/ 4" minimum (509.5 mm minimum)The completed built-in kit frame assembly dimensions:HEIGHT 19 1/ 2" (495mm)WIDTH 30" (762mm)NOTE: The bottom of the cut-out opening for built-in use must be 36 inches (915 mm) or higher from the floor.PLEASE READ THESE INSTRUCTIONS THOROUGHLY BEFORE BEGINNING INSTALLATION!The electrical requirements for this oven are 120 volts, 15 amps. The oven has a 5-15 plugand requires a 5-15 receptacle.RK-12S30Q'TY1111111112324121111* For walls other than wood, you may need screws appropriate for thatwall to install the frame.* Be sure to DISCONNECT THE PLUG of the oven from the electricaloutlet before installing the oven and kit.* Because the kits are metal, due caution should be used in handlingand installation to avoid the possibility of injury.PROVIDED PARTSSCREW (C) - LONGEXHAUST DUCT BOTTOMEXHAUST DUCTBACK EXHAUSTDUCT UPPEREXHAUSTDUCTRIGHTDIVIDE PLATE L DIVIDE PLATE RFRAMEASSEMBLYRECTIFIERPLATE LEXHAUSTDUCT LEFTREAR SPACERSCREW (B) - MIDDLESCREW (A) - SHORTTINSEB184WRRZ-D92Printed in ThailandRK12S30 2nd 09.1.14, 11:01 AM1