Sharp AX-1100 Service Manual

Also see for AX-1100: Operation manual with cookbook Operation manual with cookbook

AX1100(R)11 – 2Water draining finishes for 60sec.. (max. working time is 7min.)07 CONSUMPTION CHECKdirect select key: [STEAM-HIGH]Output switches by key operation.If no key operation continues for 60sec, output turns off.[STEAM HIGH] key*Engine heater mode with temperature control by ETH[DUAL HIGH] key*Top heater mode with temperature control at 250ºC.*Microwave mode at 70%.*EE01 is displayed when oven thermister is defect.[GRILL] key*Top heater mode with temperature control at 250ºC.*EE01 is displayed when oven thermister is defect.[MICRO] key*Microwave mode at 100%.Waiting conditionEH, RY-1(OL)FM, PMI. DAMPER: CLOSEMICRO(100%)RY-1, GH, FMI. DAMPER: CLOSERY-1, GH, FMI. DAMPER: CLOSEOven thermister errorMICRO(100%)RY-1, FMI. DAMPER: OPEN08 Monitor mode Monitor key, 60 times speed key and stage cancel key are available until powerturn off.OFFI. DAMPER : OPENdetail of testtest nameN.o output example of displayRY-1, EH, FMI. DAMPER: OPENOFFI. DAMPER: OPENOFFI. DAMPER: OPENPump motor stop for 0 sec (Flash: EP_T6_TT) to delete water by engine heating.*Flashing the right-side bar.*Work end with alarm.RY-1, EH, PM, FMI. DAMPER: OPEN06 Water drain Pushing [START] key water draining works.*To empty the water of the tank.*After work for 60 sec. (FLASH: EP_MN_PO), the next stage start.*Flashing the right-side bar.If temperature adjustment (by ETH) acts or 6 minutes pass, the next stage starts.*Temperature adjustment Flash: (EP_T6EH_H)*Many a little amount of water is left to the Engine.*Flashing the right-side bar.