Supplied AccessoriesMake sure the following accessories are provided with the product.Remote control unit "AAA" size battery AC cord Cable clamp (x 1) Stand unit Operation manual(x 1) (x2) (xl) Cable tie (x 1) (x 1) (xl)Page 7 Page 8 Page 7 Page 7 Page 6Always use the AC cord supplied with the TV.AC cord enclosed in this product is for 110-125V. In using it on the 125-240V AC, please consult the following.SHARP ELECTRONICS CORPORATION, LATIN AMERICA GROUP6100 Blue Lagoon Drive, Suite 150, Miami, Florida 33126, U.S.A.= To avoid scratching the frame or screen, please use a soft, lint free cloth for cleaning. Approved cleaning cloths are availabledirectly from Sharp in single (00Z-LCD-CLOTH) or triple (00Z-LCD-CLOTH-3) packs. Call 1-800-BE-SHARP for ordering, orVISIT www.sharpusa.com/SharpDirect.QUICK REFERENCE+ Before attaching (or detaching) the stand, unplug the AC cord from the AC INPUT terminal.+ Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from being damaged.+ Attach the stand in the correct direction.+ Do not remove the stand from the TV unless using an optional wall mount bracket to mount it.+ Be sure to follow the instructions. Incorrect installation of the stand may result in the TV falling over.Confirm that there are 8 screws (4 short screwsand 4 long screws) and a hex key supplied with thestand unit.++++llll2 Attach the supporting post for the stand unit ontothe base using the box for the stand unit as shownbelow.+ The supporting post attaches to the base at an off-centeredlocation on the base. Be sure to attach the supporting post inthe direction indicated below and attach the stand to the TVwith the wider side of the base facing forward.3 {_ Insert the stand into the openings on the bottomof the TV.{_} Insert and tighten the 4 short screws into the 4holes on the rear of the TV._Hex key_ _l_ ==@ @++Soft cushionTo detach the stand, perform the steps in reverse order.Q-6