Sharp AN-W9Z Manual

Also see for AN-W9Z: Operation manual

GB 2Mounting the Lens1 Remove the wide conversion lensfrom its original box. Put the screwthread of the wide conversion lensand the projector lens together.2 Fix the focus ring of the projectormanually. Then turn the wideconversion lens clockwise slowly.(NOTE: Mounting the lens whenthe screw thread of both lensesis incorrectly set may causedamage. Make sure that thescrew thread of both lenses is setcorrectly and then turn the wideconversion lens slowly.)3 When the wide conversion lens has been mounted, setthe part for preventing the lens from falling. (See the“Mounting the part for preventing the lens from falling”section in this manual.)Mounting the part for preventing thelens from falling1 Set the part for preventing thelens from falling as shown on theillustration. (Make sure that thepart is attached to the outer ditchof the focus ring on the projector.)2 Attach the two screws (included)using the included screwdriver.Projector lensWide conversion lensThe part for preventingthe lens from falling(included)AN_W9Z(E)#p02-05.pm6 01.12.27, 1:12 PM2Downloaded from: http://www.usersmanualguide.com/

/ 5

Related manuals for Sharp AN-W9Z