Sharp AN-C430LP Installation Manual

Contents

removing and installing the lamp unit

Printed in ChinaTINS-C573WJZZ06P07-CH-NMMANUALparticles if lamp ruptures. In case of lamp rupture, contact your nearest Sharper or Service Center* for replacement.nit from the projector right after use. The lamp will be very hot and may cause burnhour after the power cord is disconnected to allow the surface of the lamp unit tothe lamp unit.mp unit be replaced when the remaining lamp life becomes 5% or less, or when you notice apicture and color quality. The lamp life (percentage) can be checked with the on-screen display.. CUSTOMERS:projector is backed by a 90-day parts and labor limited warranty. All service of thiscluding lamp replacement, must be obtained through a Sharp Authorized ProjectorFor the name of the nearest Sharp Authorized Projector Dealer or Service Center*,O-SHARP (1-888-467-4277).MERCURY For State Lamp Disposal Informationr 1-800-BE-SHARP U.S.A. ONLYor Service Center referring to your projector operation manual.LAMP UNIT (LAMP/CAGE MODULE) FOR PROJECTORModel AN-C430LP Securing screwsstalling thenit from the projectord parts around the lampuse burn or injury.ace of the lamp unit ornd damage to the lamp,low the steps below.s except for the lamp/ON on the projec-on the remote con-ector into standbyn stops.wer cord.from the AC socket.has fully cooled downnit cover.ce screw ( 1) that se-er. Slide down ( 2) andover ( 3).4 Remove the lamp unit.• Loosen the securing screws from the lamp unit.Hold the lamp unit and pull it in the direction ofthe arrow. At this time, keep the lamp unit hori-zontal and do not tilt it.5 Insert the new lamp unit.• Press the lamp unit firmly into the lamp unitcompartment. Fasten the securing screws.6 Replace the lamp unit cover.• Align the lamp unit cover and slide it to close.Then tighten the user service screw to securethe lamp unit cover.Info• If the lamp unit and lamp unit cover are not cor-rectly installed, the power will not turn on, even ifthe power cord is connected to the projector.Resetting the Lamp TimerReset the lamp timer after replacing the lamp.Info• Make sure to reset the lamp timer only when re-placing the lamp. If you reset the lamp timer andcontinue to use the same lamp, this may causethe lamp to become damaged or explode.1 Connect the power cord.• Plug the power cord into the AC socket of theprojector.2 Reset the lamp timer.• While simultaneously holding down ", andMENU on the projector, press STANDBY/ON on the projector.• “LAMP 0000H” is displayed, indicating that thelamp timer is reset.STANDBY/ONbuttonAC socket132User service screw(for lamp unit cover)User service screw(for lamp unit cover)AC socket" buttonENTER buttonSTANDBY/ON buttonMENU button06.7.21, 10:41

/ 2

Related manuals for Sharp AN-C430LP