Sharp AL-1451 Operation Manual

Contents

183 Making copiesNORMAL COPYINGThis copier has two document input stations - a single pass feeder (SPF) for automatic documentfeeding and an original table for manual handling of documents. The SPF is designed to holdup to 30 originals measuring from 5-1/2" x 8-1/2" to 8-1/2" x 14" and weighing from 14 to 23lbs.1 Ensure that paper of the desired size is set in the paper tray. See page 13, LOADINGCOPY PAPER. When copying onto paper larger than 8-1/2" x 11" size, pull out thepaper output tray extension.2 Turn the power switch on.3 Place the original(s) face up in the document feeder tray or face down on the originaltable.A. When using the SPF:(1) Make sure that no original is left on the original table.(2) Adjust the original guides to the size of originals.(3) Set the originals face up in the document feeder tray. Before feeding originals in the document feeder tray, be sure to remove anystaples or paper clips from them. Before placing curled or wavy originals into the document feeding tray, besure to flatten them. If not, original misfeeds may result. The SPF ( ) indicator on the operation panel will light up. If this indicatordoes not light up, the originals are not properly set or the SPF is not properlyclosed. Badly damaged originals may misfeed in the SPF. It is recommended thatsuch originals be copied from the original table. Special originals such as transparency film should not be fed through theSPF, but should be placed directly on the original table.Original face up