Sharp AJ-2105 Operation Manual

Also see for AJ-1805: Online manual

20SETTING UP FOR WindowsTo use this printer with your computer, the printer driver should be installed onto yourcomputer's hard drive. In this chapter, you will learn how to install them and how to use theOnline Manual.The following term is used in this chapter.CD-ROMMeans the supplied CD-ROM with the AJ-2105 software.HARDWARE AND SOFTWARE REQUIREMENTSCheck the following hardware and software requirements in order to install the AJ-2105printer driver.*1 Compatible with Windows Me, Windows 98 or Windows 2000 preinstalled model withUSB interface equipped as standard.*2 Printing is unavailable in MS-DOS mode.BEFORE INSTALLATIONThe method to install the printer driver varies depending on your operating system and thecable connecting the printer and your computer. Check your interface and operatingsystem, and then follow the steps shown below to install the printer driver.Computer type IBM PC/AT or compatible computer equipped with aUSB* 1 or bi-directional parallel interface (IEEE1284)Operating system*2 Windows Me, Windows 98, Windows 95, Windows 2000,Windows NT 4.0 (Service Pack 3 or later)Display 640 x 480dots (VGA) or betterHard disk free space 10MB or moreOther requirement for hardware An environment on which any of the operating systemslisted above can fully operateWindows MeWindows 98Windows 2000 *Windows MeWindows 98Windows 95Windows 2000 *Windows NT 4.0 *USBParallel"Installing onto Windows Me (USB interface)" (page 21)"Installing onto Windows 98 (USB interface)" (page 23)"Installing onto Windows 2000 (USB interface)" (page 26)"Installing onto Windows Me/98/95/2000/NT4.0 (Parallel interface)"(page 28)Operating systemInterface Reference pages for how to install* The administrator's authorisation is required to install a printer driver.