Sharp 40FD2K User Manual

287. At this point, you can do any of the following:• Select Done to start watching TV.• Select Scan for channels to repeat the entire channel scan. This option deletes all existing channels and theregion and subregion selections, if applicable.• Select Rescan for channels to repeat the channel scan. This option deletes all existing channels, but retainsyour previous region and subregion selections, if applicable.• Only on certain models, select Set up Live TV Pause. You can also do this later. The topic Pausing live TVexplains how to set up and use this feature.Tip: Repeat the channel scan from time to time to make sure that you are receiving all of the latest channels.Broadcasters add and remove channels, move channels to different parts of the spectrum and change the powerlevels of their channels periodically. Your TV reception and picture quality depend on the position of your aerialand on your location relative to the transmitters of broadcasters in your area.Note: You’ll have to repeat the channel scan if you remove and re-add the Live TV input on the Home screen orperform a factory reset. To repeat the channel scan, go to Settings > TV inputs > Live TV > Scan for channels> Start finding channels.Scanning for individual channelsAfter performing a complete channel scan, you can perform a manual channel scan at any time; for example, todiscover and add new channels or channels from a different region or subregion.To manually scan for channels:1. From the Home Screen Menu, navigate to Settings > TV Inputs > Live TV > Manual scan for channels.2. Use the purple directional pad to highlight a channel multiplex and its assigned frequency in the list, andthen press OK to scan that channel multiplex.3. Wait, while the selected multiplex is scanned for individual channels.4. Press OK to confirm and return to the list of channel multiplexes.5. Repeat these steps as needed to scan for additional channels.Now, you’re ready to watch live TV! While you’re watching, try the following tips:• Press GUIDE to display the programme guide, and then use the directional pad to navigate through theguide. Press CH- or REWIND / CH+ or FAST FWD to jump through the guide a page at a time.• While in the programme guide, press OK to tune to the highlighted channel (if you are viewing programmesthat are on now).• While watching a TV programme, press OK to display information about the current programme.• Press STAR to see options for picture and sound settings.