Sharp 14J1-GF Operation Manual

Contents

TV set[ TV set (Bottom) ]Using headphoneInsert headphone plug into headphone jack to listen to audio withheadphone.• The audio from the speakers is turned off.accessories are included with this television.ntrol Size-AA batteries Operation manual Rod antenna (dipole) with ribbon feeder300-75 impedance converter(only for 14J1-GF/14J1-SF)• To avoid injuring your hearing, do not put on the headphone before plugging them into the headphone jack and beforethe power is turned on.E4 PART NAMESCESSORIESFORE OPERATING TELEVISIONAV-1 IN OUTAUDIOVIDEOCAUTION : DANGEROUSVOLTAGE INSIDETO PREVENT ELECTRIC SHOCK.DO NOT REMOVE COVER.NO UBER-SERVICEABLE PARTSINSIDE, REFER SERVICING TOQUALIFIED SERVICE PERSONAL.CAUTION : DANGEROUSVOLTAGE INSIDETO PREVENT ELECTRIC SHOCK.DO NOT REMOVE COVER.NO UBER-SERVICEABLE PARTSINSIDE, REFER SERVICING TOQUALIFIED SERVICE PERSONAL.AV-1 IN OUTAUDIOVIDEODIN45325C169-2)hmcablecable)plied)d)75-ohmimpedanceconverter(not supplied)Antenna inTVCAUTION : DANGEROUSVOLTAGE INSIDETO PREVENT ELECTRIC SHOCK.DO NOT REMOVE COVER.NO UBER-SERVICEABLE PARTSINSIDE, REFER SERVICING TOQUALIFIED SERVICE PERSONAL.AV-1 IN OUTAUDIOVIDEOAntenna inTVVCRTo antennain terminalTo RF outterminalRF terminal connection, set the TV to channel zero to make initial adjustments for the VCR.a rod antenna and the signal from TV station is weak or not clear, the picture may not display clearlythis case, we recommend that you use an outdoor antenna.r antenna uses a 75-ohm coaxialtandard DIN45325 plug (IEC 169-2),antenna jack at the rear of the set.ing to an antenna Connecting to an antenna via a VCRIf your outdoor antenna uses a 300-ohm twin-leadflat feeder, connect a 300-ohm to 75-ohmimpedance converter and plug it into the antennajack at the rear of the set.(1) Insert the rod antenna's base post into theantenna mounting socket until it clicks intoposition.(2) Connect the feeder to the impedance converter.(3) Plug the impedance converter into the antennajack at the rear of the set.• Rod antenna and impedance converter are onlyincluded in model 14J1-GF/14J1-SF.Rod AntennaFeederImpedanceConvertercket(14J1-GF/14J1-SF)nna connectionMENU/PRESET CH VIDEO AUDIOPOWERAV-2 INBottomCHPower indicatorPower can be turned on by theremote control when the indicatoris dimly.MENU/PRESET buttonTunes the channels.Used for MENU setup.MENU/PRESETVolume up/down buttonsAdjusts the volume.Makes adjustments in PRESET.Channel up/down buttonsSelects the channels.Tunes or sets the channels.Headphone jackUse to listen to the audiowith headphone.Video input terminal (AV-2 IN)Connects to a camcorder,video game, etc.Audio input terminal (AV-2 IN)Connects to a camcorder,video game, etc.Infrared sensor windowReceives the infrared wave fromthe remote control.POWERPOWER switchTurns on and off themain power.CHCH //This operation manual is for14J1-GF, 14J1-SF, 21J1-GFand 21J1-SF. The illustration of21J1-GF/21J1-SF are used inthis operation manual.(21J1-GF/21J1-SF)22/9/05, 11:24 am2