Sealey WD80 Manual

Also see for WD80: Instructions

WHEEL REMOVAL/LIFTER TROLLEY 80KG WITHQUICK LIFTMODEL NO: WD80Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,and properly maintained, give you years of trouble free performance.IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USETHE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/ORPERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.1. SAFETY9 Always lower, centre and use slide bar and safety rod before attempting to move trolley.9 Only use the trolley on firm, level, unobstructed surfaces which are capable of supporting the trolley and wheel.8 DO NOT overload the trolley - maximum capacity is 80kg.8 DO NOT ride on the trolley.8 DO NOT use on tarmacadam. The trolley must only be used on a concrete surface.9 WD80 is fitted with locking castors, these are for use at the operator’s discretion and when the trolley is left unattended.9 Replace or repair damaged parts. Use only recommended parts. Unauthorised parts may be dangerous and will invalidate the warranty.9 Use a qualified person to lubricate and maintain the trolley. DO NOT use brake fluid to top up hydraulic unit. Use Sealey hydraulic oil only. WARNING! Failure to comply with these instructions may result in loss of load, damage to trolley or other property and/or personal injury. WARNING! The warnings, cautions and instructions discussed in this manual cannot cover all possible conditions and situations thatmay occur. It must be understood that common sense and caution are factors which cannot be built into this product, but must beapplied by the operator.2. INTRODUCTIONLong reach hydraulic mechanism. Quick Lift feature reduces the time and effort needed to raise arms to contact point. Steelconstruction with friction mounted roller arms. Front and rear castors for easy manoeuvrability. Adjustable width, 300 or 360mmbetween rollers, gives greater flexibility. Supplied with safety bar to prevent wheel from tipping forward.3. SPECIFICATION4. ASSEMBLYFIG.1 FIG.2NOTE: Numbers in diagrams correspond to the item numbers on the parts diagram.Refer toinstructionmanualWearprotectiveglovesWearprotectivefootwearOriginal Language Version© Jack Sealey Limited WD80 Issue 6 (H, 2, 3) 19/10/23Model No: WD80Maximum Lifting Capacity 80kgMaximum Lifting Height: 930mmMaximum Wheel Diameter: 22”Minimum Wheel Diameter: 12’’Roller Length: 280mmWidth Between Rollers: 300, 360mm6 25

/ 3

Related manuals for Sealey WD80