Sealey VS900.V2 Instructions Manual

INSTRUCTIONS FOR:INFRARED LASER THERMOMETERModel: VS900.V2Thank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructionsand properly maintained, give you years of trouble free performance.VS900.V2 - 2 - 090304IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS AND CAUTIONS.USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSEDAMAGE AND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.1. SAFETY INSTRUCTIONS2. INTRODUCTION1.1. GENERAL SAFETYp WARNING! Ensure that Health & Safety, local authority and general workshop practice regulations areadhered to when using this equipment.p WARNING! DO NOT aim the laser beams at your or another personís or animalís eye and beware of reflectionsfrom mirrors or other shiny surfaces.3 Familiarise yourself with the applications, limitations, and potential hazards of the thermometer.3 Keep the thermometer clean and in good condition.3 Protect the thermometer from the following:Electro-magnetic fields from engine components closer than 125mm.Static electricity.Thermal shock caused by large and/or rapid ambient temperature change.High temperatures.8 DO NOT get the thermometer wet or use in damp or wet locations or areas where there is condensation.8 DO NOT use the thermometer for any purpose other than for which it is designed.8 DO NOT allow untrained persons (particularly children) to operate the thermometer.8 DO NOT operate the thermometer when you are tired or under the influence of alcohol, drugs orintoxicating medication.SPECIFICATIONTemperature Range ................................-50 to 280OC (-58 to 536OF)Ambient Operating Range ............................0 to 50OC (32 to 122OF)Response time ....................................................Less than 1 secondAccuracy @ 18OC to 28OC Ambient,Target Temperature ..........................................................Accuracy-50 to -20OC ..............................................................................±5OC-20 to -280OC ............................................................±2% of readingOver range indication ..............................................LCD will show ë1íEmissivity ..................................................................0.95 fixed valueLaser ....................Output <1mW, Wavelength 630-670nm Class llDisplay ..........................................3-1/2 digit LCD with backlightingDisplay Hold Time ................................................7 seconds approx.Battery ....................................9V Alkaline or Ni-Cad (not supplied)Weight ..............................................................................180gramsNew way to tackle diagnosis of engine and vehicle faults. VS900.V2 detects energy emission in the infra-red spectrum and converts itinto a temperature reading. Features laser pointer to indicate area being sampled. Temperature is displayed on large LCD panel with backlitdisplay for use in low light areas. Temperature can be shown in either OC or OF. Powered by 9V battery (not included).MAIN FEATURES1. Infrared sensor2. Laser pointer beam3. LCD Display4. OF select key5. OC select key6. Laser select key7. Backlight select key8. Measurement trigger9. Battery cover10. Handle grip fig. 11.2 LASER SAFETYThe VS900.V2 utilises a Class II laser that emits low levels of visible radiation (i.e. wavelengths between 400 and 700 nanometres) whichare safe for the skin but not inherently safe for the eyes. The Class II emission limit is set at the maximum level for which eye protection isnormally afforded by natural aversion responses to bright light. Accidental eye exposure is therefore normally safe, although the naturalaversion response can be overridden by deliberately staring into the beam, and can also be influenced by the use of alcohol or drugs.p WARNING! Do not look or stare into the laser beam as permanent eye damage could result.7 DO NOT direct the laser beam at any personís (or animalís) eyes as eye damage could result.8 DO NOT operate the thermometer when you are tired or under the influence of alcohol, drugs or intoxicating medication.3 Be aware that reflections of the laser beam from mirrors or other shiny surfaces can be as hazardous as direct eye exposure.

/ 3

Related manuals for Sealey VS900.V2