Menu
Sealey UWRC01 Manual
  |
1. SAFETY8 DO NOT enter the danger zone (the area of the winch drum, the fairlead (if fitted), the pulley block (if used) the hook and the motor).8 DO NOT approach or span the wire rope whilst the winch or puller is under load.8 DO NOT operate a winch or puller when under the influence of alcohol, drugs or medication. WARNING! Turn off the power switch on the side of the hand held control unit, before working in or around the fairlead or wire rope drum(the danger zone). WARNING! Never tuck the hand held control unit under the arm, or allow anyone else to hold it, so as to avoid it being accidentallyactivated.9 Wear eye protection, insulated work clothes, non-slip shoes, keep hair tied up and wear thick leather gloves. Remove all jewellery.9 Inspect winch or puller, wire rope, hooks and other accessories frequently. A mashed, pinched, kinked or frayed wire rope with brokenstrands should be replaced at once, because a damaged rope has reduced load carrying capability.NOTE: The safety precautions and instructions discussed in this manual can't cover all possible conditions and situations that may occur.It must be understood by the operator that common sense and caution are factors which cannot be built into this product and must beapplied by the operator.2. INTRODUCTIONUniversal wireless remote control kit has a 4-pin plug-and-play receiver. With a range of up to 30m (dependant on environment), awireless remote control is an essential accessory. Weatherproof receiver and handset making it ideal for off-roaders and recoverytrucks, enabling the operator to stand well clear or sit in the cab (provided there are no restrictions).3. SPECIFICATIONModel No: ........................................................ UWRC01Battery:...........................................MN21 23A (supplied)Contents:............................... Handheld Control Unit (x1)........................... 4-Pin Plug-and-Play Receiver Unit (x1)Range: ..................................................................... 30m4. OPERATION4.1. Fit the battery by sliding off the cover, taking care to observe the polarity indicated on the circuit board. Replace cover.4.2. Remove the waterproof cover from the four pin socket on the end of the winch and fit the receiver unit. Take note of the orientation ofthe key way on the receiver unit. Tighten the securing ring.4.3. Turn on the switch on the side of the hand held control unit.4-PIN UNIVERSAL WINCH REMOTE CONTROLMODEL NO: UWRC01Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,and properly maintained, give you years of trouble free performance.IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USETHE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/ORPERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.Refer toinstructionmanualUWRC01 Issue 2 (ALL) 03/07/23Original Language Version© Jack Sealey Limited |
Related manuals for Sealey UWRC01
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved