Menu
Sealey SM40.V2 Instructions Manual
   |
instructions forparts cleaning tankmodel no: sm40.V2thank you for purchasing a sealey product. manufactured to a high standard, this product will, if used according to these instructions,and properly maintained, give you years of trouble free performance.IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USETHE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/ORPERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.1. saFetY1.1. electrical saFetY Warning! it is the user’s responsibility to check the following:check all electrical equipment and appliances to ensure that they are safe before using. inspect power supply leads, plugs and allelectrical connections for wear and damage. sealey recommend that an rcd (residual current device) is used with all electricalproducts. You may obtain an rcd by contacting your local sealey dealer.if the product is used in the course of business duties, it must be maintained in a safe condition and routinely PAt (Portable Appliancetest) tested.electrical safety information: it is important that the following information is read and understood.1.1.1. ensure that the insulation on all cables and on the appliance is safe before connecting it to the power supply.1.1.2. regularly inspect power supply cables and plugs for wear or damage and check all connections to ensure that they are secure.1.1.3. important: Ensure that the voltage rating on the appliance suits the power supply to be used and that the plug is fitted with the correctfuse - see fuse rating in these instructions.8 DO nOt pull or carry the appliance by the power cable.8 DO nOt pull the plug from the socket by the cable.8 DO nOt use worn or damaged cables, plugs or connectors. ensure that any faulty item is repaired orreplaced immediately by a qualified electrician.1.1.4. This product is fitted with a BS1363/A 13 Amp 3 pin plug.if the cable or plug is damaged during use, switch the electricity supply and remove from use.Ensure that repairs are carried out by a qualified electrician.Replace a damaged plug with a BS1363/A 13 Amp 3 pin plug. If in doubt contact a qualified electrician.A) Connect the GREEN/YELLOW earth wire to the earth terminal ‘E’.B) Connect the BROWN live wire to the live terminal ‘L’.C) Connect the BLUE neutral wire to the neutral terminal ‘N’.ensure that the cable outer sheath extends inside the cable restraint and that the restraint is tight.Sealey recommend that repairs are carried out by a qualified electrician.if an extension reel is used it should be fully unwound before connection. A reel with an rcd fitted ispreferred since any appliance plugged into it will be protected. the cable core section is important and should be at least 1.5mm², but tobe absolutely sure that the capacity of the reel is suitable for this product and for others which may be used in the other output sockets,we recommend the use of 2.5mm² section cable.1.2 general saFetY Warning! ensure health & safety, local authority, and general workshop practice regulations are adhered to when using this equipment.9 familiarise yourself with application and limitations, as well as the specific potential hazards peculiar to the cleaning tank. Warning! disconnect the cleaning tank from the mains power before changing accessories, servicing or performing any maintenance.9 maintain the cleaning tank in good condition (use an authorised service agent).9 replace or repair damaged parts. use genuine parts only. unauthorised parts may be dangerous and will invalidate the warranty.9 locate the cleaning tank in a suitable working area. ensure the washer is stood on a firm level surface. Keep area clean and tidy and freefrom unrelated materials. ensure the area is well ventilated and has adequate lighting.9 Keep the cleaning tank away from heat sources such as heater, sparks, open flames etc.9 Keep the cleaning tank clean. remove and clean the filter regularly for best and safest performance.9 ensure there are no flammable or combustible materials near the work area. Warning! Always wear approved eye or face protection when operating the cleaning tank.9 remove ill fitting clothing. remove ties, watches, rings, and other loose jewellery, and contain long hair.9 Wear appropriate protective clothing.9 maintain correct balance and footing. ensure the floor is not slippery and wear non-slip shoes.9 Keep children and unauthorised persons away from the working area.9 Avoid accidental starting of the pump by ensuring the unit is unplugged from the mains power when not in use.9 in case of fire in parts unit, do not attempt to remove parts, or the tank. the lid is fusible and will automatically close to extinguish flames.8 DO nOt modify or jam the cleaning tank lid open, as this will make the fusible fire link inoperative which is dangerous practice and willinvalidate the warranty and your insurance.9 When cleaning parts ensure that nothing in the tank, including any parts basket, is in a position that would prevent the lid fromclosing fully if and when the fusible link activates.replacement fuse 3amp rating:sM40.V2 | Issue 2 (H,F) 10/11/17Original Language Version© Jack sealey limitedrefer to instructionmanual Wear ProtectiveGlovesWear EyeProtectionWear a Mask Wear Protectiveclothing flammablematerial |
Related manuals for Sealey SM40.V2
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved