Menu
Sealey SM3002DFD Instructions Manual
    |
DIGITAL FEED DISPLAY FOR SM3002MODEL: SM3002DFDThank you for purchasing a Sealey product. Manufactured to a high standard this product will, if used according to these instructionsand properly maintained, give you years of trouble free performance.IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS.USE THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGEAND/OR PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. PLEASE KEEP INSTRUCTIONS SAFE FOR FUTURE USE.INSTRUCTIONS FOR:1. INTRODUCTIONDigital display for the cross slide and the compound tool rest to replace the standard graduated scales. These LCD units improve accuracy, savereading time and minimise errors. Imperial or Metric readings may be selected and the reading can be zeroed at any point. Three decimal place(Metric) and four decimal place (Imperial) displays with an accuracy of ± 0.025mm/0.001””.2. CONTENTS3. INSTALLATION 13.1 Loosen the compound rest gibs(fig 1a) and crank the compound restfeed handle anticlockwise to remove thetop of the compound rest from thecompound rest bottom.3.2 Undo the handle screw of the graduatedscale (fig 2a) and remove the spring clipand scale (fig 2b). Remove the compoundrest screw retainer (fig 2c) (retaining thefixing screws for future use) and removethe compound rest feed screw.3.3 Remove the two large hex screws(fig 3a) (retaining them for future use).Remove the compound restbottom (fig 3b) from the cross slide.3.4 Move the protractor (fig 4a) to thenew compound rest bottom (fig 4b) andslide the compound rest top (fig 4c) ashort way onto the new compound restbottom, being sure to leave the two largescrew holes uncovered.3.5 Screw the compound rest back ontothe cross slide using the two large hexscrews. Adjust the gib screws so that thecompound rest may be moved by handbut with some resistance.3.6 Screw the new compound rest feedscrew into the compound rest bottom.Installing the Compound Rest digital display.1. Cross slide feed screw2. Compound rest feed screw3. Screws and spacers4. Cross slide screw retainer5. Cross slide feed nut6. Compound rest screw retainer7. Compound rest bottom8. Digital displays1 2 6 54783fig 1 fig 2 fig 3fig 4 fig 5 fig 6ac b aa ba bc© Jack Sealey Limited Original Language Version SM3002DFD Issue: Issue: 2(L) - 12/05/16 |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved