Menu
Sealey SM220 Manual
   |
14L PORTABLE BUCKET PARTS WASHERWITH BRUSHMODEL NO: SM220Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to theseinstructions, and properly maintained, give you years of trouble free performance.IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USETHE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/ORPERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.1. SAFETY1.1. ELECTRICAL SAFETY WARNING! It is the user’s responsibility to check the following:Check all electrical equipment and appliances to ensure that they are safe before using. Inspect power supply leads, plugs and allelectrical connections for wear and damage. Sealey recommend that an RCD (Residual Current Device) is used with all electricalproducts.If the product is used in the course of business duties, it must be maintained in a safe condition and routinely PAT (Portable ApplianceTest) tested.Electrical safety information: it is important that the following information is read and understood.1.1.1. Ensure that the insulation on all cables and on the appliance is safe before connecting it to the power supply.1.1.2. Regularly inspect power supply cables and plugs for wear or damage and check all connections to ensure that they are secure.1.1.3. Important: Ensure that the voltage rating on the appliance suits the power supply to be used and that the plug is fitted with the correctfuse - see fuse rating in these instructions.8 DO NOT pull or carry the appliance by the power cable.8 DO NOT pull the plug from the socket by the cable.8 DO NOT use worn or damaged cables, plugs or connectors. Ensure that any faulty item is repaired orreplaced immediately by a qualified electrician.1.1.4. This product is fitted with a BS1363/A 3 pin plug.If the cable or plug is damaged during use, switch the electricity supply and remove from use.Ensure that repairs are carried out by a qualified electrician.Replace a damaged plug with a BS1363/A 3 pin plug. If in doubt contact a qualified electrician.A) Connect the GREEN/YELLOW earth wire to the earth terminal ‘E’.B) Connect the BROWN live wire to the live terminal ‘L’.C) Connect the BLUE neutral wire to the neutral terminal ‘N’.Ensure that the cable outer sheath extends inside the cable restraint and that the restraint is tight.Sealey recommend that repairs are carried out by a qualified electrician. WARNING! The supply cord cannot be replaced. If the cord is damaged the appliance should be scrapped.NOTE: The pump is to be supplied by an isolating transformer or supplied through a residual current device having a rated residualoperating current not exceeding 30mA.1.2. GENERAL SAFETY WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this equipment.9 Familiarise yourself with product application and limitations, as well as the specific potential hazards peculiar to the washer. WARNING! Disconnect the washer from the mains power before changing accessories, servicing or performing any maintenance.8 DO NOT unplug machine with wet hands.9 Maintain the washer in good condition (use an authorised service agent).9 Replace or repair damaged parts. Use genuine parts only. Non-authorised parts may be dangerous and will invalidate the warranty.9 Locate the washer in an adequate working area for its function. Ensure the washer stands on a firm level surface. Keep area clean andtidy and free from unrelated materials. Ensure the area is well ventilated and has adequate lighting.9 Keep the washer away from heat sources such as heater, sparks, open flames etc.9 Keep the washer clean. Remove and clean regularly for best and safest performance.9 Ensure there are no flammable or combustible materials near the work area. WARNING! Always wear approved eye or face protection when operating the washer along with protective gloves (see Sealey Cataloguefor suitable gloves, we recommend part no. SSP32).9 Remove ill fitting clothing. Remove ties, watches, rings and other loose jewellery, and contain long hair.9 Wear appropriate protective clothing.9 Maintain correct balance and footing. Ensure the floor is not slippery and wear non-slip shoes.9 Keep children and unauthorised persons away from the working area.9 Avoid accidental starting of the washer. Ensure that it is unplugged from the mains supply when not in use.8 DO NOT use the washer for any purpose other than for which it is designed.8 DO NOT use the washer where there are flammable liquids, solids or gases.8 DO NOT allow untrained persons to operate the washer.8 DO NOT operate the washer if any parts are missing or damaged as this may cause failure or possible personal injury.Refer toinstructionsElectrical shockhazardWear eyeprotectionWear protectiveglovesWear protectiveclothingReplacement fuserating: 13ASM220 Issue 2 (1,F) 10/07/23Original Language Version© Jack Sealey Limited |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved