Sealey SA44.V4 Instructions Manual

INSTRUCTIONS FORAIR ANGLE GRINDER 100MM HEAVY DUTYMODEL NO: SA44.V4Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,and properly maintained, give you years of trouble free performance.IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USETHE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/ORPERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.1. SAFETY WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using thisequipment. WARNING!Disconnect from air supply before changing accessories or servicing.9 Maintain the grinder in good condition (use an authorised service agent).9 Replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty.9 Use in a suitable work area. Keep area free from unrelated materials and ensure that there is adequate lighting.9 Before each use check abrasive disc for condition. If worn or damaged replace immediately.9 Ensure the speed rating (rpm) of the disc is the same as, or greater than, the speed rating of the grinder.9 Ensure there are no flammable or combustible materials near the work area. WARNING! Always wear approved eye (or face) and hand protection when operating the grinder.9 Use face, dust, or respiratory protection in accordance with COSHH regulations.9 Depending on the task, grinder noise level may exceed 85dB in which case wear safety ear defenders.9 Remove ill fitting clothing. Remove ties, watches, rings, other loose jewellery and contain and/or tie back long hair.9 Wear appropriate protective clothing and keep hands and body clear of working parts.9 Maintain correct balance and footing. Ensure the floor is not slippery and wear non-slip shoes.9 Keep children and unauthorised persons away from the working area.9 Check moving parts alignment on a regular basis.9 Ensure workpiece is secure before operating the grinder. Never hold a workpiece by hand.9 Check the workpiece to ensure there are no protruding screws, bolts, nuts etc.9 Avoid unintentional starting. WARNING! Ensure correct air pressure is maintained and not exceeded. Recommended pressure 90psi.9 Keep air hose away from heat, oil and sharp edges. Check air hose for wear before each use and ensure that all connections are secure.9 Prolonged exposure to vibration from this grinder poses a health risk. It is the owner’s responsibility to correctly assess the potentialhazard and issue guidelines for safe periods of use and offer suitable protective equipment.8 DO NOT use the grinder for a task it is not designed to perform.8 DO NOT operate grinder if any parts are damaged or missing as this may cause failure and/or personal injury. WARNING! DO NOT grind any materials containing asbestos.8 DO NOT carry the grinder by the hose, or pull the hose from the air supply.8 DO NOT force, or apply heavy pressure to, the grinder, let the tool do the work.8 DO NOT place air line attachments close to your face and DO NOT point at other people or animals.8 DO NOT operate grinder when you are tired or under the influence of alcohol, drugs or intoxicating medication.8 DO NOT use grinder where there are flammable liquids, solids or gases such as paint solvents and including waste wiping or cleaningrags etc.8 DO NOT carry the grinder with your finger on the power lever.8 DO NOT direct air from the air line at yourself or others.9 When not in use disconnect from air supply and store in a safe, dry, childproof location.1.1. LEAD PAINT WARNING!Paint once contained lead as a traditional ingredient. Contact with the dust from the removal of such paint is toxic and musttherefore be avoided. The following action must be taken before using the grinder on a surface that you suspect may contain leadpaint.1. User must determine potential hazard relating to age of paint to be removed (modern paints do not have lead content).2. DANGER! Keep all people and pets away from the working area. The following are particularly vulnerable to the effects of lead paintdust: Expectant women, babies and children.3. We recommend personal protection by using the following safety items:a) Paint Spray Respirator (Our ref SSP1699)b) PE Coated Hooded Coverall (Our ref SSP267).c) Latex Gloves (Our ref SSP24).4. Take adequate measures to contain the paint dust, flakes and scrapings.5. Continue to wear safety equipment as in (3) above and thoroughly clean all areas when work is complete. Ensure paint waste isdisposed of in sealed bags or containers.Refer toinstructionmanualWear eyeprotectionWeargloves WearprotectiveclothingWear earprotection Wear a maskSA44.V4| Issue:1 13/03/17Original Language Version© Jack Sealey Limited

/ 3

Related manuals for Sealey 5024209160216