Sealey RPS2KD Instructions Manual

UNIVERSAL MOTORCYCLE WHEEL STANDS(FRONT AND REAR) WITH RUBBER SUPPORTS KDMODEL NO: RPS2KD (REAR), FPS1KD (FRONT)Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,and properly maintained, give you years of trouble free performance.IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USETHE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/ORPERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.1. SAFETY WARNING! Before use, ensure that there is nothing attached to the front forks, the fairing, or the rear end of the motorcycle, thatwill foul the stand.8 DO NOT mount the stand on tarmacadam, as the surface may be unstable.8 DO NOT start the motorcycle when mounted on the stand.8 DO NOT sit on the motorcycle when mounted on the stand.8 DO NOT use the stand for a purpose it is not designed to perform.8 DO NOT operate the stand if it is damaged or parts are missing.8 DO NOT use the stand when you are tired or under the influence of alcohol, drugs or intoxicating medication.8 DO NOT allow untrained persons to operate the stand.8 DO NOT make any modifications to the stand.8 DO NOT operate the stand if parts are missing or damaged.9 Maintain the stand in a good clean condition for the best and safest performance.9 Locate the stand and motorcycle in a suitable area. Keep area clean, tidy and free from unrelated materials and ensure that there isadequate lighting. Also ensure that the floor/ground is level and strong enough (preferably concrete) to take the weight of the standand the motorcycle.9 Maintain correct balance and footing whilst positioning the motorcycle on the stand, DO NOT over reach.9 Ensure that the floor is not slippery, wear non-slip footwear.9 Keep children and unauthorised persons away from the work area.9 Before loading or removing a motorcycle to/from the stand, ensure that there are no obstructions or persons around the motorcycle.9 Always support bike to prevent falling.9 Although the stand can be operated by one person, we advise seeking the assistance of a second person when mounting / dismountingthe stand.9 Always use in conjunction with another suitable rear stand to ensure full stability.9 When not in use, store in a safe, dry, childproof location. WARNING: The warnings, cautions and instructions in this manual cannot cover all possible conditions and situations that may occur.It must be understood that common sense and caution are factors which cannot be built into this product, but must be appliedby the operator.2. INTRODUCTIONRPS2KD (Rear Stand)Lifts and stabilises any dual swing arm motorbike quickly and easily. Fitted with width and angle adjustable rubber support pads. Rubber supportsmounted on heavy-duty box section for continuous professional use. Bobbin Supports available as an optional extra - Model No. RPS1BS.Delivered in knock-down form to reduce freight costs, some self-assembly required. Min./Max. Width: 220-350mm.FPS1KD (Front Stand)Features width adjustment from 180 to 255mm, making it suitable for almost all motorbikes. Design ensures rim and tyre protection at all times.Once the bike is supported, allows easy removal and cleaning of front wheel. Please note all front paddock stands need to be used in conjunctionwith a suitable rear stand to ensure bike stability (See Model No. RPS2KD). Delivered in knock-down form to reduce freight costs, some self-assembly required.RPS2KDRPS2KD, FPS1KD Issue 1 19/07/22Original Language Version© Jack Sealey LimitedRefer toinstructionmanualWear protectivegloves Wear protectivefootwearFPS1KD

/ 2

Related manuals for Sealey FPS1KD